>> Why the procedure is not getting the performance advantage of Vacuum >> analyse? >Plan caching by the function, probably. Try disconnecting the session >and reconnecting to prove the hypothesis. >If it is a recurring problem for you, you could put the SELECT under >EXECUTE in the function. But most likely this is just a one-time >problem. Is there any way to clear the cached plan manually other than disconnecting (With the help of some commands/Configuration settings) ? Visit our Website at http://www.rmesi.co.in This message is confidential. You should not copy it or disclose its contents to anyone. You may use and apply the information for the intended purpose only. Internet communications are not secure; therefore, RMESI does not accept legal responsibility for the contents of this message. Any views or opinions presented are those of the author only and not of RMESI. If this email has come to you in error, please delete it, along with any attachments. Please note that RMESI may intercept incoming and outgoing email communications. Freedom of Information Act 2000 This email and any attachments may contain confidential information belonging to RMESI. Where the email and any attachments do contain information of a confidential nature, including without limitation information relating to trade secrets, special terms or prices these shall be deemed for the purpose of the Freedom of Information Act 2000 as information provided in confidence by RMESI and the disclosure of which would be prejudicial to RMESI's commercial interests. This email has been scanned for viruses by Trend ScanMail. ---------------------------(end of broadcast)--------------------------- TIP 9: In versions below 8.0, the planner will ignore your desire to choose an index scan if your joining column's datatypes do not match
