Hi All,
I have a procedure which contains only one Select statement.
The procedure take more time than expected to complete, the select statement
inside the procedure was taking about 2 minutes to complete.
After running a Vacuum Analyze on the underlying tables the
select statement could complete within seconds. But the procedure was still
taking long time.
I tried after recreating the procedure, the procedure is
taking only a few seconds after recreation.
Why the procedure is not getting the performance advantage
of Vacuum analyse?
Regards,
Anoo
Visit our Website at www.rmesi.co.in
This message is confidential. You should not copy it or disclose its contents to anyone. You may use and apply the information for the intended purpose only. Internet communications are not secure; therefore, RMESI does not accept legal responsibility for the contents of this message. Any views or opinions presented are those of the author only and not of RMESI. If this email has come to you in error, please delete it, along with any attachments. Please note that RMESI may intercept incoming and outgoing email communications.
Freedom of Information Act 2000
This email and any attachments may contain confidential information belonging to RMESI. Where the email and any attachments do contain information of a confidential nature, including without limitation information relating to trade secrets, special terms or prices these shall be deemed for the purpose of the Freedom of Information Act 2000 as information provided in confidence by RMESI and the disclosure of which would be prejudicial to RMESI's commercial interests.
This email has been scanned for viruses by Trend ScanMail.
