read the memory mapped address - pcie - kernel hangs

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi All,

I have module with Xilinx FPGA. It implements UART(s), SPI(s),
parallel I/O and interfaces them to the Host CPU via PCI Express bus.
I see that my system freezes without capturing the crash dump for certain tests.
I debugged this issue and it was tracked down to the ‘readl()’ in
interrupt handler code

In ISR, first reads the Interrupt Status register using ‘readl()’ as
given below.
    status = readl(ctrl->reg + INT_STATUS);

And then clears the pending interrupts using ‘writel()’ as given blow.
        writel(status, ctrl->reg + INT_STATUS);

I've noticed a kernel hang if INT_STATUS register read again after
clearing the pending interrupts.

My system freezes only after executing the same ISR code after
millions of interrupts. Basically reading the memory mapped register
in ISR resulting this behavior.
If I comment “status = readl(ctrl->reg + INT_STATUS);” after clearing
the pending interrupts then system is stable .

As a temporary workaround I avoided reading the INT_STATUS register
after clearing the pending bits, and this code change works fine.

Can someone clarify me why the kernel hangs without crash dump incase
if I read the INT_STATUS register using readl() after
clearing(writel()) the pending bits?

To read the memory mapped IO kernel provides {read}{b,w,l,q}() API’s.
If PCIe card is not responsive , can call to readl() from interrupt
context makes system freeze?

Thanks for any suggestions and solutions to this problem!

Snippet of the ISR code is given blow:
https://pastebin.com/as2tSPwE


static irqreturn_t pcie_isr(int irq, void *data)

{

        struct test_device *ctrl = (struct test_device *)data;

        u32 status;

…



        status = readl(ctrl->reg + INT_STATUS);

        /*

         * Check to see if it was our interrupt

         */

        if (!(status & 0x000C))

                return IRQ_NONE;



        /* Clear the interrupt */

        writel(status, ctrl->reg + INT_STATUS);



        if (status & 0x0004) {

                /*

                 * Tx interrupt pending.

                 */

                 ....

       }



        if (status & 0x0008) {

                /* Rx interrupt Pending */

                /* The system freezes if I read again the INT_STATUS
register as given below */

                status = readl(ctrl->reg + INT_STATUS);

                ....

        }

..

        return IRQ_HANDLED;
}

-- 
Thanks,
Sekhar

_______________________________________________
Kernelnewbies mailing list
Kernelnewbies@xxxxxxxxxxxxxxxxx
https://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies




[Index of Archives]     [Newbies FAQ]     [Linux Kernel Mentors]     [Linux Kernel Development]     [IETF Annouce]     [Git]     [Networking]     [Security]     [Bugtraq]     [Yosemite]     [MIPS Linux]     [ARM Linux]     [Linux RAID]     [Linux SCSI]     [Linux ACPI]

  Powered by Linux