I'm not sure what project i'm looking to apply, maybe a netdev driver?
Or two network protocol driver with a userspace daemon/utilities to
control the antenna? Or just a userspace daemon/utilities.
I don't have a clear idea where I should write the code that controls
the antenna.
Il 01/04/19 20:28, Andrea Laisa ha scritto:
Il 01/04/19 19:16, Greg KH ha scritto:
Who is "you" here? What project specifically are you looking to apply
to that asked you to post on the kernelnewbies list?
As "you" I mean all linux kernel hacker.
Il 01/04/19 19:16, Greg KH ha scritto:
- do you have documentation for how this protocol works?
- do you have access to hardware where you could test these kernel
changes?
Yes, I have access to my home antenna (and access point), but I don't
have any tyoe of official documentation because it doesn't exist or I
doesnt't found it,
I have sniffed my network traffic between the access point and the
antenna and I discovered(with wireshark) that they use a custom
protocol over LCC (dsap 0x40 and 0x10) to setup the connection to my
ISP via LTE. After the setup the AP routes the LAN network traffic to
the antenna as expected over a 802.1q-tagged IP packet(with VLAN
ID=1121).
Although I don't have access to the protocol specifications, I'm going
to reverse engineering the protocol!
_______________________________________________
Kernelnewbies mailing list
Kernelnewbies@xxxxxxxxxxxxxxxxx
https://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
