Re: enabling two eths

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, 20 Feb 2007 18:51:41 +0530
Manjunath AM <Manjunath.AM@xxxxxxxxxxxx> wrote:

> Hi,
> 
> We are using MPC8272 based target board, we use montavista Linux version 
> 2.6.10 kernel image (with NFS enabled) to our target board,
> 
> Our board has  2 FCCs (eth0 and eth1). bot the eth's works perfectly when 
> we use them independently, but when we are trying to enable second one 
> after the kernel is up using linux command  "ifconfig eth1 192.168.33.64 
> up"(IP address)nothing is working.
> Please suggest how to enable second eth (either 0 or 1) once the kernel is 
> up with NFS file system
> 

I could recall no problems with mpc8272 except stuck PHY which were cured by board power cycle.
I brought up second Ethernet interface a number of times without any problem; even had them replace each 
other serving as NFS root gate.

So I would suggest supplying more information on "nothing is working", prolly kernel output and details about MVL product you are using.

-- 
Sincerely, 
Vitaly

--
To unsubscribe from this list: send an email with
"unsubscribe kernelnewbies" to ecartis@xxxxxxxxxxxx
Please read the FAQ at http://kernelnewbies.org/FAQ


[Index of Archives]     [Newbies FAQ]     [Linux Kernel Mentors]     [Linux Kernel Development]     [IETF Annouce]     [Git]     [Networking]     [Security]     [Bugtraq]     [Yosemite]     [MIPS Linux]     [ARM Linux]     [Linux RAID]     [Linux SCSI]     [Linux ACPI]
  Powered by Linux