Hello all, I have a target board running linux. The target has built in Ethernet chip, which I could able to configure by passing parameters through commnd line(cmdline.c) and it is running fine. The target board has PCI interface also. Now I added PCI ethernet adapter to the same target board. I added one more "ip" param in the cmdline.c, but I am not able to bring it up.(when I do ifconfig it is not showing the new ethernet interface). I used the following cmdline.c const char cmdline[] = "mem=64M root=/dev/nfs console=ttyS0,115200 nfsroot=10.72.149.201:/work/nfsroot,v3 ip=10.72.148.7:10.72.149.201:10.72.149.201:255.255.248.0:target01:eth0:off ip=10.72.148.8:10.72.149.201:10.72.149.201:255.255.248.0:target01:eth1:off"; Any hints ? Thanks in Advance Ramprasad ----- Original Message ----- From: "John Levon" <levon@movementarian.org> To: "Neale Banks" <neale@lowendale.com.au> Cc: <kernelnewbies@nl.linux.org> Sent: Wednesday, January 08, 2003 12:47 PM Subject: Re: Configure.help in 2.5 ??? > On Wed, Jan 08, 2003 at 05:44:33PM +1100, Neale Banks wrote: > > > > > Is there something I should have read and which would have made this > > "obvious"? > > Documentation/kbuild > > Though it may not be mentioned yet, I haven't checked > > john > -- > "CUT IT OUT FACEHEAD" > - jeffk > -- > Kernelnewbies: Help each other learn about the Linux kernel. > Archive: http://mail.nl.linux.org/kernelnewbies/ > FAQ: http://kernelnewbies.org/faq/ > -- Kernelnewbies: Help each other learn about the Linux kernel. Archive: http://mail.nl.linux.org/kernelnewbies/ FAQ: http://kernelnewbies.org/faq/
