> -----Original Message----- > From: netfilter-owner@xxxxxxxxxxxxxxx [mailto:netfilter-owner@xxxxxxxxxxxxxxx] > On Behalf Of ??????????? ?????? > Sent: Monday, August 04, 2008 3:26 AM > To: barich@xxxxxxxxxxxxxx > Cc: 'Mail List - Netfilter' > Subject: RE: UDP stream load balancing across multiple uplinks > > В Пнд, 28/07/2008 в 09:33 -0400, Barry A Rich пишет: > > > -----Original Message----- > > > From: netfilter-owner@xxxxxxxxxxxxxxx > > > [mailto:netfilter-owner@xxxxxxxxxxxxxxx] > > > On Behalf Of Grant Taylor > > > Sent: Friday, July 25, 2008 11:10 AM > > > > > > Given that the source IP of your packets can change mid stream, you > > > could use the "nth" match extension. Using "nth" you would match > > > packets to decide how to mark them and then use the mark to determine > > > what routing table to use which would ultimately decide which outbound > > > path to use. > > > > The following setup does load balancing across the uplinks. However, the > > source address in the outgoing packets is not being SNAT'ed. Any > > suggestions? > > Only first packet of udp "connection" is reaching the rule in the nat > table and does the job, since nat occurs for all packets in this > connection rest of rules would not match. I understand better. I removed the following rule: #iptables -t raw -A PREROUTING -i eth0 -p udp --sport $SPORT -j NOTRACK The connection is tracked and the outgoing UDP packets are SNAT-ed. However, the source address for all UDP packets is the IP address of the uplink assigned to the connection (regardless of the uplink they actually are sent). Is there a way to SNAT without connection tracking? -- To unsubscribe from this list: send the line "unsubscribe netfilter" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
