On Wednesday 14 July 2004 5:10 pm, Hudson Delbert J Contr 61 CS/SCBN wrote: > where is the ruleset. never saw it in any message traffic. It was attached to the original request for people to proofread it (if you didn't see the script, what did you proofread!?). 4.6k textfile called rc.iptables I've attached it again to this email so you can see it (I hope others on the list don't mind the duplicate posting - it's not a very long script...) Regards, Antony. > -----Original Message----- > From: netfilter-admin@xxxxxxxxxxxxxxxxxxx > [mailto:netfilter-admin@xxxxxxxxxxxxxxxxxxx]On Behalf Of Antony Stone > Sent: Wednesday, July 14, 2004 5:13 AM > To: netfilter > Subject: Re: Proofreading > > On Wednesday 14 July 2004 1:00 pm, Erik Wikström wrote: > > On Tue, Jul 13, 2004 at 04:19:57PM -0700, Hudson Delbert J Contr 61 > > CS/SCBN > > wrote: > > > X...ports 6k --> at least 6100 > > > rpc... > > > nfs > > > > > > shall i go on. > > > > Please do. > > I don't quite understand this. Perhaps Hudson has not noticed the default > DROP policy in Erik's ruleset? > > Regards, > > Antony. -- I don't know, maybe if we all waited then cosmic rays would write all our software for us. Of course it might take a while. - Ron Minnich, Los Alamos National Laboratory Please reply to the list; please don't CC me.
#!/usr/bin/bash # -------------------- # | Initialize | # -------------------- # Variables IPT="/usr/sbin/iptables" WAN="eth0" LAN="eth1" LOCAL_NET="192.168.10.0/24" # Computers Yorthen="192.168.10.2" Ohm="192.168.10.10" # Clear all rules and set policies for table in filter mangle nat ; do $IPT -t $table -F # Flush all rules $IPT -t $table -X # Remove all non-builtin chains $IPT -t $table -Z # Reset all counters # Set policies for chain in FORWARD INPUT OUTPUT PREROUTING POSTROUTING ; do if [ $table == "filter" ] ; then $IPT -t $table -P $chain DROP # Default to filter out all packages else $IPT -t $table -P $chain ACCEPT fi done done # Add custom chains $IPT -t filter -N bad_packets # --------------------- # | bad_packets | # --------------------- # Drop INVALID and other bad packets $IPT -t filter -A bad_packets -m state --state INVALID -j DROP $IPT -t filter -A bad_packets -p TCP --tcp-flags SYN,ACK SYN,ACK -m state --state NEW -j DROP $IPT -t filter -A bad_packets -p TCP ! --syn -m state --state NEW -j DROP # Drop spoofed addresses $IPT -t filter -A bad_packets -i $WAN -s 192.168.0.0/16 -j DROP $IPT -t filter -A bad_packets -s 172.16.0.0/12 -j DROP $IPT -t filter -A bad_packets -s 127.0.0.0/8 -j DROP $IPT -t filter -A bad_packets -i $LAN -s ! $LOCAL_NET -j DROP # -------------- # | LYRA | # -------------- # Allow already established connections $IPT -t filter -A OUTPUT -m state --state ESTABLISHED,RELATED -j ACCEPT $IPT -t filter -A INPUT -m state --state ESTABLISHED,RELATED -j ACCEPT # Allow traffic on loopback interface $IPT -t filter -A INPUT -i lo -j ACCEPT $IPT -t filter -A OUTPUT -o lo -j ACCEPT # Drop bad_packages $IPT -t filter -A INPUT -j bad_packets # Allow firewall to get WAN-IP from DHCP $IPT -t filter -A OUTPUT -o $WAN -p UDP --dport 67 --sport 68 -j ACCEPT $IPT -t filter -A INPUT -i $WAN -p UDP --sport 67 --dport 68 -j ACCEPT # Allow computers on LAN to get IP from DHCP $IPT -t filter -A INPUT -i $LAN -p UDP --dport 67 --sport 68 -j ACCEPT $IPT -t filter -A OUTPUT -o $LAN -p UDP --sport 67 --dport 68 -j ACCEPT # Allow SSH-connections from both LAN and WAN $IPT -t filter -A INPUT -i $LAN -p TCP --syn -s $LOCAL_NET --dport 22 -j ACCEPT $IPT -t filter -A INPUT -i $WAN -p TCP --syn --dport 2070 -j ACCEPT # Allow DNS-requests $IPT -t filter -A OUTPUT -o $WAN -p UDP --dport 53 -j ACCEPT # Allow HTTP-requests $IPT -t filter -A OUTPUT -o $WAN -p TCP --dport 80 -j ACCEPT # Allow FTP-requests $IPT -t filter -A OUTPUT -o $WAN -p TCP --dport 21 -j ACCEPT # Allow SSH to LAN $IPT -t filter -A OUTPUT -o $LAN -d $LOCAL_NET -p TCP --dport 22 -j ACCEPT # Reject Ident-requests $IPT -t filter -A INPUT -i $WAN -p TCP --dport 113 -j REJECT --reject-with tcp-reset # ------------------- # | LOCAL_NET | # ------------------- # Allow already established connections through $IPT -t filter -A FORWARD -m state --state ESTABLISHED,RELATED -j ACCEPT # Drop bad_packages $IPT -t filter -A FORWARD -j bad_packets # Drop SMB-packages $IPT -t filter -A FORWARD -p TCP --sport 137:139 -j DROP $IPT -t filter -A FORWARD -p UDP --sport 137:139 -j DROP $IPT -t filter -A FORWARD -p TCP --sport 445 -j DROP $IPT -t filter -A FORWARD -p UDP --sport 445 -j DROP # Allow traffic from LAN to WAN $IPT -t filter -A FORWARD -i $LAN -o $WAN -s $LOCAL_NET -j ACCEPT $IPT -t nat -A POSTROUTING -o $WAN -s $LOCAL_NET -j MASQUERADE # Forward SSH to Ohm $IPT -t nat -A PREROUTING -i $WAN -p TCP --syn --dport 22 -j DNAT --to $Ohm $IPT -t filter -A FORWARD -i $WAN -d $Ohm -p TCP --dport 22 -j ACCEPT # Forward DC++ to Yorthen $IPT -t nat -A PREROUTING -i $WAN -p TCP --syn --dport 1436 -j DNAT --to $Yorthen $IPT -t filter -A FORWARD -i $WAN -d $Yorthen -p TCP --dport 1436 -j ACCEPT $IPT -t nat -A PREROUTING -i $WAN -p UDP --dport 1436 -j DNAT --to $Yorthen $IPT -t filter -A FORWARD -i $WAN -d $Yorthen -p UDP --dport 1436 -j ACCEPT # Forward FTP to Yorthen $IPT -t nat -A PREROUTING -i $WAN -p TCP --syn --dport 1045:1050 -j DNAT --to $Yorthen $IPT -t filter -A FORWARD -i $WAN -d $Yorthen -p TCP --dport 1045:1050 -j ACCEPT $IPT -t nat -A PREROUTING -i $WAN -p TCP --syn --dport 2069 -j DNAT --to $Yorthen $IPT -t filter -A FORWARD -i $WAN -d $Yorthen -p TCP --dport 2069 -j ACCEPT # Forward DCC to Yothen $IPT -t nat -A PREROUTING -i $WAN -p TCP --syn --dport 59 -j DNAT --to $Yorthen $IPT -t filter -A FORWARD -i $WAN -d $Yorthen -p TCP --dport 59 -j ACCEPT # ---------------- # | SYSCTL | # ---------------- echo "1" > /proc/sys/net/ipv4/ip_forward echo "1" > /proc/sys/net/ipv4/ip_dynaddr echo "1" > /proc&sys/net/ipv4/conf/eth0/rp_filter echo "1" > /proc/sys/net/ipv4/conf/eth1/rp_filter
