hello everyone,
This is my problem:
As a gateway in my network is a PC with Linux ( Slackware 8.1 ), and
also on this machine is installed MRTG that listen for SNMP. I want to use SNMP
only in local ( internal ) network. I know that SNMP
use 161 and 162 port. There are no problems with comunication between
Linux machine and local hosts via SNMP.
BUT: the problem is when MRTG try to receive SNMP information from this
same machine that is installed ( MRTG is installed on Linux machine -
gateway). I dont know why because i set: iptables -A INPUT -i eth1 -p tcp -m multiport --dport 21,80,161,3128 -j ACCEPT
iptables -A INPUT -i eth1 -p udp -m multiport --dport 80,67,161 -j ACCEPT
...and it should resolve problem...but
it wont
!!!!!THIS IS IMPORTANT!!!!
when I set all INPUT ACCETP then it works. So there is no problem with
snmp and MRTG but with my iptables config :/
I use:
NET-SNMP version: 5.0.7
iptables v1.2.6a
This is my iptables config:
insmod ip_conntrack
insmod ip_conntrack_ftp
iptables -P FORWARD DROP
iptables -P INPUT DROP
iptables -P OUTPUT ACCEPT
iptables -A INPUT -m state --state ESTABLISHED,RELATED -j ACCEPT
iptables -A INPUT -p tcp -m multiport --dport 22 -j ACCEPT
iptables -A INPUT -i eth1 -p tcp -m multiport --dport 21,80,161,3128 -j ACCEPT
iptables -A INPUT -i eth1 -p udp -m multiport --dport 80,67,161 -j ACCEPT
iptables -A FORWARD -m state --state ESTABLISHED,RELATED -j ACCEPT
iptables -A FORWARD -i eth1 -p tcp -m multiport --dport 21,22,25,110,1111,6112 -j ACCEPT
iptables -A FORWARD -i eth1 -p udp -m multiport --dport 53,6112,13073,23083,23073 -j ACCEPT
iptables -I INPUT -p icmp --icmp-type echo-request -s 0.0.0.0/0 -m limit --limit 1/s -j ACCEPT
iptables -I INPUT -p icmp --icmp-type echo-request -s 0.0.0.0/0 -j DROP
#===NAT=================================================================================
modprobe iptable_nat
iptables -t nat -A POSTROUTING -o ppp0 -j MASQUERADE
echo 1 > /proc/sys/net/ipv4/ip_forward
Will be thankful for any good advice
--
Best regards,
