i.e.
Consider the following network: (kindly view the attached txt file for a
nicer one)
inet
|
|
|203.190.72.108
*-----------------*
10.0.0.1| eth0 |none
/----|eth1 eth2|------\ new network
block pipe
| | LINUX GW | line cut *--------*
192.168.129.x/24 (network)
| *-----------------* | |
10.0.0.2, gw for 192.168.129.x/24 block under LINUX GW
| | 192.x |
| | |
*HUB*-----------------------------------------*--------*
| cisco 2600
router ip of this router is: 10.0.0.2
|
|
*--* *--* *--*
| | | | | |
| | | | | |
*--* *--* *--*
workstations
10.0.0.0/16 block
interface:
- eth0 = 203.190.72.108, default gw.
- eth1 = 10.0.0.0/16, local area network.
- eth2 = none
===========
Right now im inside 10.0.0.0/16 block, my ip is 10.0.0.11 and my default gw
is via 203.190.72.108.
My LAN is on a masq LinuxBOX. On my diagram i have added a network cable
that is on a different
subnet connect to a cisco router via 10.0.0.2 which is connected to another
network (diff story).
My kernel route diagram is below..
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
203.190.72.104 0.0.0.0 255.255.255.248 U 0 0 0 eth0
192.168.129.0 10.0.0.2 255.255.255.0 UG 0 0 0 eth1
<--- new route via 10.0.0.2
10.0.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth1
0.0.0.0 203.190.72.110 0.0.0.0 UG 0 0 0 eth0
I can access ip block 192.168.129.x on my LINUX GW perfectly. But when im on
my workstations on
10.0.0.11 block i cannot even ping 192.168.129.x block. Which could be
possibly be wrong?
---
thanks,
louie
Consider the following network:
inet
|
|
|203.190.72.108
*-----------------*
10.0.0.1| eth0 |none
/----|eth1 eth2|------\ new network block pipe
| | LINUX GW | line cut *--------* 192.168.129.x/24 (network)
| *-----------------* | | 10.0.0.2, gw for 192.168.129.x/24 block under LINUX GW
| | 192.x |
| | |
*HUB*-----------------------------------------*--------*
| cisco 2600 router ip of this router is: 10.0.0.2
|
|
*--* *--* *--*
| | | | | |
| | | | | |
*--* *--* *--*
workstations
10.0.0.0/16 block
interface:
- eth0 = 203.190.72.108, default gw.
- eth1 = 10.0.0.0/16, local area network.
- eth2 = none
