Hi, On Wed, 15 Dec 2010, Mr Dash Four wrote: > I've just looked at the code and man pages for the above - it makes some > interesting reading! > > I have a question though - Would it be possible for me to specify port ranges > as well - if not at the members level, then at least from the command line? > > For example, with the current setup if I want to include 'low' ports in a set, > then I have to run a separate script with a 'count' value from 1 to 1024 and > execute 1024 different 'ipset -A' statements to include that particular port > into the set. The situation is much worse if I am dealing with high-ports - > for obvious reasons. > > Would it be possible to be able to specify port ranges (say, '1-1024') in a > similar fashion as it is currently done with ip address ranges? I don't completely understand you: the bitmap:port type already supports adding/deleting port ranges. Could you write a full example? Best regards, Jozsef - E-mail : kadlec@xxxxxxxxxxxxxxxxx, kadlec@xxxxxxxxxxxx PGP key : http://www.kfki.hu/~kadlec/pgp_public_key.txt Address : KFKI Research Institute for Particle and Nuclear Physics H-1525 Budapest 114, POB. 49, Hungary -- To unsubscribe from this list: send the line "unsubscribe netfilter-devel" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
