[PATCH v4 3/7] i2c: designware: allow IP specific sda_hold_time

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Because some old designware IPs were not supporting setting an SDA hold
time, vendors developed their own solution. Add a way for the final driver
to provide its own SDA hold time handling.

Reviewed-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
Signed-off-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxx>
---
 drivers/i2c/busses/i2c-designware-common.c | 2 ++
 drivers/i2c/busses/i2c-designware-core.h   | 1 +
 2 files changed, 3 insertions(+)

diff --git a/drivers/i2c/busses/i2c-designware-common.c b/drivers/i2c/busses/i2c-designware-common.c
index bcc1bcbf0350..4f4bcefbf404 100644
--- a/drivers/i2c/busses/i2c-designware-common.c
+++ b/drivers/i2c/busses/i2c-designware-common.c
@@ -214,6 +214,8 @@ int i2c_dw_set_sda_hold(struct dw_i2c_dev *dev)
 		dev_dbg(dev->dev, "SDA Hold Time TX:RX = %d:%d\n",
 			dev->sda_hold_time & ~(u32)DW_IC_SDA_HOLD_RX_MASK,
 			dev->sda_hold_time >> DW_IC_SDA_HOLD_RX_SHIFT);
+	} else if (dev->set_sda_hold_time) {
+		dev->set_sda_hold_time(dev);
 	} else if (dev->sda_hold_time) {
 		dev_warn(dev->dev,
 			"Hardware too old to adjust SDA hold time.\n");
diff --git a/drivers/i2c/busses/i2c-designware-core.h b/drivers/i2c/busses/i2c-designware-core.h
index cdba58a3e359..ad4e9619d365 100644
--- a/drivers/i2c/busses/i2c-designware-core.h
+++ b/drivers/i2c/busses/i2c-designware-core.h
@@ -282,6 +282,7 @@ struct dw_i2c_dev {
 	void			(*disable)(struct dw_i2c_dev *dev);
 	void			(*disable_int)(struct dw_i2c_dev *dev);
 	int			(*init)(struct dw_i2c_dev *dev);
+	int			(*set_sda_hold_time)(struct dw_i2c_dev *dev);
 	int			mode;
 	struct i2c_bus_recovery_info rinfo;
 };
-- 
2.18.0





[Index of Archives]     [Linux MIPS Home]     [LKML Archive]     [Linux ARM Kernel]     [Linux ARM]     [Linux]     [Git]     [Yosemite News]     [Linux SCSI]     [Linux Hams]

  Powered by Linux