The integration of the Designware SPI controller on Microsemi SoCs requires an extra register set to be able to give the IP control of the SPI interface. Cc: Rob Herring <robh+dt@xxxxxxxxxx> Signed-off-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxx> --- Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt b/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt index 204b311e0400..d97b9fc4c1cb 100644 --- a/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt +++ b/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt @@ -1,8 +1,9 @@ Synopsys DesignWare AMBA 2.0 Synchronous Serial Interface. Required properties: -- compatible : "snps,dw-apb-ssi" -- reg : The register base for the controller. +- compatible : "snps,dw-apb-ssi" or "mscc,<soc>-spi" +- reg : The register base for the controller. For "mscc,<soc>-spi", a second + register set is required (named ICPU_CFG:SPI_MST) - interrupts : One interrupt, used by the controller. - #address-cells : <1>, as required by generic SPI binding. - #size-cells : <0>, also as required by generic SPI binding. -- 2.18.0
