Hi, The MIPS based Xilfpga platform uses the axi interrupt controller daisy chained to the MIPS microAptiv cpu interrupt controller. This patch series moves the axi interrupt controller driver out of arch/microblaze to drivers/irqchip. This makes it usable by MIPS. The rest of the series basically enables drivers and adds dt nodes. Would make sense for this to go via the MIPS tree. Hence, ACKs from microblaze. irqchip and net welcome. Regards, ZubairLK Note: Compile tested on microblaze only! Based on v4.8-rc2 Zubair Lutfullah Kakakhel (9): microblaze: irqchip: Move intc driver to irqchip irqchip: xilinx: Add support for parent intc MIPS: xilfpga: Use irqchip_init instead of the legacy way MIPS: xilfpga: Use Xilinx AXI Interrupt Controller MIPS: xilfpga: Update DT node and specify uart irq MIPS: Xilfpga: Add DT node for AXI I2C net: ethernet: xilinx: Enable emaclite for MIPS MIPS: xilfpga: Add DT node for AXI emaclite MIPS: xilfpga: Update defconfig arch/microblaze/Kconfig | 1 + arch/microblaze/kernel/Makefile | 2 +- arch/mips/Kconfig | 1 + arch/mips/boot/dts/xilfpga/nexys4ddr.dts | 64 ++++++++++++++++++++++ arch/mips/configs/xilfpga_defconfig | 37 ++++++++++++- arch/mips/xilfpga/intc.c | 7 +-- drivers/irqchip/Kconfig | 4 ++ drivers/irqchip/Makefile | 1 + .../kernel/intc.c => drivers/irqchip/irq-xilinx.c | 28 +++++++++- drivers/net/ethernet/xilinx/Kconfig | 4 +- 10 files changed, 139 insertions(+), 10 deletions(-) rename arch/microblaze/kernel/intc.c => drivers/irqchip/irq-xilinx.c (90%) -- 1.9.1
