From: David Daney <ddaney.cavm@xxxxxxxxx> Date: Fri, 22 Jun 2012 17:24:13 -0700 > From: David Daney <david.daney@xxxxxxxxxx> > > The IEEE802.3 clause 45 MDIO bus protocol allows for directly > addressing PHY registers using a 21 bit address, and is used by many > 10G Ethernet PHYS. Already existing is the ability of MDIO bus > drivers to use clause 45, with the MII_ADDR_C45 flag. Here we add > struct phy_c45_device_ids to hold the device identifier registers > present in clause 45. struct phy_device gets a couple of new fields: > c45_ids to hold the identifiers and is_c45 to signal that it is clause > 45. > > Normally the MII_ADDR_C45 flag is ORed with the register address to > indicate a clause 45 transaction. Here we also use this flag in the > *device* address passed to get_phy_device() to indicate that probing > should be done with clause 45 transactions. > > EXPORT phy_device_create() so that the follow-on patch to of_mdio.c > can use it to create phy devices for PHYs, that have non-standard > device identifier registers, based on the device tree bindings. > > Signed-off-by: David Daney <david.daney@xxxxxxxxxx> I see no value in having two ways to say that clause-45 transactions should be used. Either make it a PHY device attribute, or specify it in the address in the register accesses, but not both. Also your patch is full of coding style errors, I simply couldn't stomache applying this even if I agreed with the substance of the changes: > + i < ARRAY_SIZE(c45_ids->device_ids) && > + c45_ids->devices_in_package == 0; c45_ids on the second line should line up with the initial 'i' on the first line. > + c45_ids->devices_in_package = (phy_reg & 0xffff) << 16; > + > + > + reg_addr = MII_ADDR_C45 | i << 16 | 5; There is not reason in the world to have two empty lines there, it looks awful. > + /* > + * If mostly Fs, there is no device there, > + * let's get out of here. > + */ Format comments: /* Like * this. */ Not. /* * Like * this. */ > + c45_ids->device_ids[i] = (phy_reg & 0xffff) << 16; > + > + > + reg_addr = MII_ADDR_C45 | i << 16 | MII_PHYSID2; Two empty lines. This is extremely irritating, it looks like you had some kind of debugging code here and then were very lazy about removing it. > +/* > + * Or MII_ADDR_C45 into regnum for read/write on mii_bus to enable the > + * 21 bit IEEE 802.3ae clause 45 addressing mode used by 10GIGE phy > + * chips. Also may be ORed into the device address in > + * get_phy_device(). > + */ Comment formatting. > +/* > + * phy_c45_device_ids: 802.3-c45 Device Identifiers > + * > + * devices_in_package: Bit vector of devices present. > + * device_ids: The device identifer for each present device. > + */ If you're going to list the struct members use the correct kerneldoc format to do so.
