From: Florian Fainelli <ffainelli@xxxxxxxxxx>
Though BCM6345 does not technically have the same MPI register layout
than the other SoCs, reading the chip-select registers is done the same
way, and particularly for chip-select 0, which is the boot flash.
Now that BCM6345 has a MPI_BASE register defined, use it.
Signed-off-by: Florian Fainelli <florian@xxxxxxxxxxx>
---
arch/mips/bcm63xx/boards/board_bcm963xx.c | 21 ++++++---------------
1 files changed, 6 insertions(+), 15 deletions(-)
diff --git a/arch/mips/bcm63xx/boards/board_bcm963xx.c b/arch/mips/bcm63xx/boards/board_bcm963xx.c
index 40b223b..ac948c2 100644
--- a/arch/mips/bcm63xx/boards/board_bcm963xx.c
+++ b/arch/mips/bcm63xx/boards/board_bcm963xx.c
@@ -709,15 +709,9 @@ void __init board_prom_init(void)
char cfe_version[32];
u32 val;
- /* read base address of boot chip select (0)
- * 6345 does not have MPI but boots from standard
- * MIPS Flash address */
- if (BCMCPU_IS_6345())
- val = 0x1fc00000;
- else {
- val = bcm_mpi_readl(MPI_CSBASE_REG(0));
- val &= MPI_CSBASE_BASE_MASK;
- }
+ /* read base address of boot chip select (0) */
+ val = bcm_mpi_readl(MPI_CSBASE_REG(0));
+ val &= MPI_CSBASE_BASE_MASK;
boot_addr = (u8 *)KSEG1ADDR(val);
/* dump cfe version */
@@ -893,12 +887,9 @@ int __init board_register_devices(void)
bcm63xx_dsp_register(&board.dsp);
/* read base address of boot chip select (0) */
- if (BCMCPU_IS_6345())
- val = 0x1fc00000;
- else {
- val = bcm_mpi_readl(MPI_CSBASE_REG(0));
- val &= MPI_CSBASE_BASE_MASK;
- }
+ val = bcm_mpi_readl(MPI_CSBASE_REG(0));
+ val &= MPI_CSBASE_BASE_MASK;
+
mtd_resources[0].start = val;
mtd_resources[0].end = 0x1FFFFFFF;
--
1.7.4.1
