On Thu, Jun 11, 2009 at 10:28:39AM +0200, Florian Fainelli wrote:
> Le Friday 05 June 2009 00:20:20 Thomas Bogendoerfer, vous avez écrit :
> > On Thu, Jun 04, 2009 at 04:22:46PM +0200, Florian Fainelli wrote:
> > > We discussed that in private, there are a couple of things
> > > to fix in order to get 8250 working properly with TI AR7 HW.
> > > If you can still merge that bit, this would ease future work, thanks !
> >
> > I still have a tree here, which works without any changes to the 8250
> > serial driver on a TNETD7300 device.
>
> Could you show me how you register the 8250 driver ? Without the 8250-specific
static struct plat_serial8250_port uart0_data = {
.mapbase = AR7_REGS_UART0,
.irq = AR7_IRQ_UART0,
.regshift = 2,
.iotype = UPIO_MEM,
.flags = UPF_BOOT_AUTOCONF | UPF_IOREMAP,
};
uart_port[0].type = PORT_16550A;
uart_port[0].line = 0;
uart_port[0].irq = AR7_IRQ_UART0;
uart_port[0].uartclk = ar7_bus_freq() / 2;
uart_port[0].iotype = UPIO_MEM;
uart_port[0].mapbase = AR7_REGS_UART0 + 3;
uart_port[0].membase = ioremap(uart_port[0].mapbase, 256);
uart_port[0].regshift = 2;
res = early_serial_setup(&uart_port[0]);
if (res)
return res;
the +3 comes from the fact, that this machine is configured to run big
endian.
Here is the boot log:
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x8610e03 (irq = 15) is a 16550A
console handover: boot [early0] -> real [ttyS0]
serial8250: ttyS1 at MMIO 0x8610f00 (irq = 19) is a 16550A
loop: module loaded
Fixed MDIO Bus: probed
ttyS1 uses the wrong address, but there is nothing connected to
that port on the box.
Do you see the problem on TNETD7200 devices as well ?
Thomas.
--
Crap can work. Given enough thrust pigs will fly, but it's not necessary a
good idea. [ RFC1925, 2.3 ]
