Hello, I wrote:
Signed-off-by: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx>
---
Here's the fragment I missed in the initial patch. Combine them if possible...
So, Ralf, will you apply this patch as is or I need to do something about
it (like adding log message)?
arch/mips/au1000/pb1000/board_setup.c | 7 -------
1 files changed, 7 deletions(-)
Index: linux-2.6/arch/mips/au1000/pb1000/board_setup.c
===================================================================
--- linux-2.6.orig/arch/mips/au1000/pb1000/board_setup.c
+++ linux-2.6/arch/mips/au1000/pb1000/board_setup.c
@@ -153,13 +153,6 @@ void __init board_setup(void)
au_writel(0x280E3D07, MEM_STTIME3); /* 250ns cycle time */
au_writel(0x10000000, MEM_STADDR3); /* any PCMCIA select */
-#ifdef CONFIG_PCI
- au_writel(0, PCI_BRIDGE_CONFIG); // set extend byte to 0
- au_writel(0, SDRAM_MBAR); // set mbar to 0
- au_writel(0x2, SDRAM_CMD); // enable memory accesses
- au_sync_delay(1);
-#endif
-
/* Enable Au1000 BCLK switching - note: sed1356 must not use
* its BCLK (Au1000 LCLK) for any timings */
switch (prid & 0x000000FF)
WBR, Sergei
