Hello, Ralf, Pete,
The current ohci-hcd driver is a little defective.
It's unable to use usb-ohci as modules in the case when PCI and on-chip
USB are enabled.
It just will not be compiled since there are two calls if module_init in
ohci-hcd.
Please look at the patch attached.
I 'm not sure is this patch well for this situation.
Any suggestions are very appreciated.
TIA,
Vladimir
--- linux-2.6.10.orig/drivers/usb/host/ohci-hcd.c 2005-12-02 16:37:59.000000000 +0300
+++ linux-2.6.10/drivers/usb/host/ohci-hcd.c 2005-12-02 19:34:21.000000000 +0300
@@ -906,8 +906,12 @@ MODULE_LICENSE ("GPL");
#endif
#ifdef CONFIG_PNX8550
+#if defined(CONFIG_PCI) && defined(CONFIG_USB_OHCI_HCD_MODULE)
+#error "unable to compile PNX8550 USB and PCI USB as modules simultaneously until usb hcd stack is rewritten"
+#else
#include "ohci-pnx8550.c"
#endif
+#endif
#ifdef CONFIG_USB_OHCI_HCD_PPC_SOC
#include "ohci-ppc-soc.c"
@@ -919,6 +923,7 @@ MODULE_LICENSE ("GPL");
|| defined (CONFIG_ARCH_LH7A404) \
|| defined (CONFIG_PXA27x) \
|| defined (CONFIG_SOC_AU1X00) \
+ || defined (CONFIG_PNX8550) \
|| defined (CONFIG_USB_OHCI_HCD_PPC_SOC) \
)
#error "missing bus glue for ohci-hcd"
