|
Hi,
I'm trying to get the 2.4 kernel running on
rbtx4927 toshiba eval board.
There are config options to enable the board
support in the kernel tree and also some relatively recent patches
specific to the board. However the furthest I
could get in the boot process is to the calibration of the delay
loop.
I'm not sure whether all of the interrupts
are disabled or just the timer, but jiffies are not getting
incremented. As far as I could trace it so far, the right irq setup
routines are called in the init, but to no avail. I'm using
mipsel-linux-gcc version 2.95.4. version 2.95.3 had the same results.
I have tried linux_2_4 and linux_2_4_22_rc3 tags of the cvs
Thanks
Yuri
|
