Re: SGI harddisk only - Debian install

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



sorry for the distrib...
boot tftpboot.img root=/dev/ram
works fine, i thought i tried it before  once again, sorry for the distrib

----- Original Message -----
From: "Garrick Evans" <sginux@yahoo.com>
To: "Linux MIPS" <linux-mips@oss.sgi.com>
Sent: Thursday, November 15, 2001 1:42 PM
Subject: SGI harddisk only - Debian install


> Just looking for a little help here getting woody running on an indy.
> My problem is once I boot the install kernel (linux), after the scsi snoop
> and network setup, it all dies on the following line:
>
> sending SDTR 011030130f0csync_xfer=2c<0>Kernel panic: VFS: Unable to mount
> root fs on 08:01
>
> I have IRIX (5.3) on dksc(0,1) and two free drives dksc(0,3) and dksc(0,4)
> available for debian.
> I have the following files located at / and /boot directories on IRIX
> partition:
> linux, root.bin, root.tar.gz, kernel_config, drivers.tgz
>
> I have booted from the "maintainence console" (PROM) with almost every
> combination I can think of - always with the same failure.
>
> So... where is it looking to mount from? Do I need to make a new
filesystem
> in the root parition of the scsi 3 disk and push the kernel and root.bin
> over there? If so, do I also then need to dvhtool the header on that disk
as
> well?
>
> Any help would be HUGELY appreciated.  Thanks.
>
>
> g
>
>
> _________________________________________________________
> Do You Yahoo!?
> Get your free @yahoo.com address at http://mail.yahoo.com


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com


[Index of Archives]     [Linux MIPS Home]     [LKML Archive]     [Linux ARM Kernel]     [Linux ARM]     [Linux]     [Git]     [Yosemite News]     [Linux SCSI]     [Linux Hams]

  Powered by Linux