SGI harddisk only - Debian install

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Just looking for a little help here getting woody running on an indy.
My problem is once I boot the install kernel (linux), after the scsi snoop
and network setup, it all dies on the following line:

sending SDTR 011030130f0csync_xfer=2c<0>Kernel panic: VFS: Unable to mount
root fs on 08:01

I have IRIX (5.3) on dksc(0,1) and two free drives dksc(0,3) and dksc(0,4)
available for debian.
I have the following files located at / and /boot directories on IRIX
partition:
linux, root.bin, root.tar.gz, kernel_config, drivers.tgz

I have booted from the "maintainence console" (PROM) with almost every
combination I can think of - always with the same failure.

So... where is it looking to mount from? Do I need to make a new filesystem
in the root parition of the scsi 3 disk and push the kernel and root.bin
over there? If so, do I also then need to dvhtool the header on that disk as
well?

Any help would be HUGELY appreciated.  Thanks.


g


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com


[Index of Archives]     [Linux MIPS Home]     [LKML Archive]     [Linux ARM Kernel]     [Linux ARM]     [Linux]     [Git]     [Yosemite News]     [Linux SCSI]     [Linux Hams]

  Powered by Linux