Hello,
OK..this is the normal kernel straight from CVS (010117) on my I2 (not
Indy as in yesturday..)
It seems a lot of things are repeated for some reason ?!?
Also, lolo was right...it doesn't shut down..
>> bootp():/vmlinux root=/dev/sda3 console=ttyS0
Obtaining /vmlinux from server slinky
ARCH: SGI-IP22
PROMLIB: ARC firmware Version 1 Revision 10
CPU: MIPS-R4400 FPU<MIPS-R4400FPC> ICACHE DCACHE SCACHE
Loading R4000 MMU routines.
CPU revision is: 00000460
Primary instruction cache 16kb, linesize 16 bytes.
Primary data cache 16kb, linesize 16 bytes.
Secondary cache sized at 1024K linesize 128 bytes.
Linux version 2.4.0 (ian@slinky) (gcc version 2.95.3 19991030
(prerelease)) #2 1
MC: SGI memory controller Revision 3
Determined physical RAM map:
memory: 00001000 @ 00000000 (reserved)
memory: 00001000 @ 00001000 (reserved)
memory: 001d6000 @ 08002000 (reserved)
memory: 00568000 @ 081d8000 (usable)
memory: 000c0000 @ 08740000 (ROM data)
memory: 05800000 @ 08800000 (usable)
On node 0 totalpages: 57344
zone(0): 57344 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/sda3 console=ttyS0
Calibrating system timer... 1000000 [200.00 MHz CPU]
zs0: console input
Console: ttyS0 (Zilog8530)
ARCH: SGI-IP22
PROMLIB: ARC firmware Version 1 Revision 10
CPU: MIPS-R4400 FPU<MIPS-R4400FPC> ICACHE DCACHE SCACHE
Loading R4000 MMU routines.
CPU revision is: 00000460
Primary instruction cache 16kb, linesize 16 bytes.
Primary data cache 16kb, linesize 16 bytes.
Secondary cache sized at 1024K linesize 128 bytes.
Linux version 2.4.0 (ian@slinky) (gcc version 2.95.3 19991030
(prerelease)) #2 1
MC: SGI memory controller Revision 3
Determined physical RAM map:
memory: 00001000 @ 00000000 (reserved)
memory: 00001000 @ 00001000 (reserved)
memory: 001d6000 @ 08002000 (reserved)
memory: 00568000 @ 081d8000 (usable)
memory: 000c0000 @ 08740000 (ROM data)
memory: 05800000 @ 08800000 (usable)
On node 0 totalpages: 57344
zone(0): 57344 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/sda3 console=ttyS0
Calibrating system timer... 1000000 [200.00 MHz CPU]
zs0: console input
Console: ttyS0 (Zilog8530)
Calibrating delay loop... Calibrating delay loop... 99.94 BogoMIPS
99.94 BogoMIPS
Memory: 91792k/95648k available (1560k kernel code, 3856k reserved, 88k
data, 7)
Memory: 91792k/95648k available (1560k kernel code, 3856k reserved, 88k
data, 7)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Checking for 'wait' instruction... Checking for 'wait' instruction...
unavaila.
unavailable.
POSIX conformance testing by UNIFIX
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Based upon Swansea University Computer Society NET3.039
Starting kswapd v1.8
Starting kswapd v1.8
initialize_kbd: Keyboard failed self test
initialize_kbd: Keyboard failed self test
Keyboard timed out[1]
Keyboard timed out[1]
pty: 256 Unix98 ptys configured
pty: 256 Unix98 ptys configured
keyboard: Timeout - AT keyboard not present?
keyboard: Timeout - AT keyboard not present?
keyboard: Timeout - AT keyboard not present?
keyboard: Timeout - AT keyboard not present?
DS1286 Real Time Clock Driver v1.0
DS1286 Real Time Clock Driver v1.0
streamable misc devices registered (keyb:150, gfx:148)
streamable misc devices registered (keyb:150, gfx:148)
sgiseeq.c: David S. Miller (dm@engr.sgi.com)
sgiseeq.c: David S. Miller (dm@engr.sgi.com)
eth0: SGI Seeq8003 eth0: SGI Seeq8003 08:08:00:00:69:69:08:08:9d:9d:ec
ec
SCSI subsystem driver Revision: 1.00
SCSI subsystem driver Revision: 1.00
wd33c93-0: chip=WD33c93B/13 no_sync=0xff no_dma=0wd33c93-0:
chip=WD33c93B/13 no0
debug_flags=0x00
setup_args= setup_args=,,,,,,,,,,,,,,,,,,
Version 1.25 - 09/Jul/1997, Compiled Jan 17 2001 at 11:41:43
Version 1.25 - 09/Jul/1997, Compiled Jan 17 2001 at 11:41:43
wd33c93-1: chip=WD33c93B/13 no_sync=0xff no_dma=0wd33c93-1:
chip=WD33c93B/13 no0
debug_flags=0x00
setup_args= setup_args=,,,,,,,,,,,,,,,,,,
Version 1.25 - 09/Jul/1997, Compiled Jan 17 2001 at 11:41:43
Version 1.25 - 09/Jul/1997, Compiled Jan 17 2001 at 11:41:43
scsi0 : SGI WD93
scsi0 : SGI WD93
scsi1 : SGI WD93
scsi1 : SGI WD93
sending SDTR sending SDTR
0101030301013f3f0c0csync_xfer=2csync_xfer=2c VendoA
Type: Direct-Access Type: Direct-Access
ANSI S2
Detected scsi disk sda at scsi0, channel 0, id 4, lun 0
Detected scsi disk sda at scsi0, channel 0, id 4, lun 0
SCSI device sda: 4226725 512-byte hdwr sectors (2164 MB)
SCSI device sda: 4226725 512-byte hdwr sectors (2164 MB)
Partition check:
Partition check:
sda: sda: sda1 sda1 sda2 sda2 sda3 sda3 sda4 sda4 sda5 sda5 sda6 sda6
SGI Zilog8530 serial driver version 1.00
SGI Zilog8530 serial driver version 1.00
tty00 at 0xbfbd9830 (irq = 21)tty00 at 0xbfbd9830 (irq = 21) is a
Zilog8530
is a Zilog8530
tty01 at 0xbfbd9838 (irq = 21)tty01 at 0xbfbd9838 (irq = 21) is a
Zilog8530
is a Zilog8530
NET4: Linux TCP/IP 1.0 for NET4.0
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: IP Protocols: ICMP, ICMP, UDP, UDP, TCP
TCP
IP: routing cache hash table of 2048 buckets, 16Kbytes
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
TCP: Hash tables configured (established 16384 bind 16384)
Sending BOOTP requests...Sending BOOTP requests..... OK
OK
IP-Config: Got BOOTP answer from 192.168.0.11, IP-Config: Got BOOTP
answer from3
my address is 192.168.0.13
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing prom memory: 768kb freed
Freeing prom memory: 768kb freed
Freeing unused kernel memory: 72k freed
Freeing unused kernel memory: 72k freed
INIT: version 2.78 booting
Bringing up the loopback interface...[ OK ]
Setting up hostname...[ OK ]
[SNIP]
root:~# cat /proc/cpuinfo
cpu : MIPS
cpu model : R4000SC V6.0
system type : SGI Indigo2
BogoMIPS : 0.00
byteorder : big endian
unaligned accesses : 0
wait instruction : no
microsecond timers : yes
extra interrupt vector : no
hardware watchpoint : yes
VCED exceptions : not available
VCEI exceptions : not available
root:~# cat /proc/iomem
00000000-00000fff : reserved
00001000-00001fff : reserved
08002000-081d7fff : reserved
08002000-08188297 : Kernel code
0819c300-081b23bf : Kernel data
081d8000-0873ffff : System RAM
08740000-087fffff : System RAM
08800000-0dffffff : System RAM
root:~# uname -a
Linux dale 2.4.0 #2 Wed Jan 17 11:40:09 GMT 2001 mips unknown
root:~# free -m
total used free shared buffers
cached
Mem: 89 34 54 0 26
5
-/+ buffers/cache: 2 86
Swap: 0 0 0
root:~#
On reboot, I get *LOTS* of rubbish coming down the serial console.
About to try the DEBUG thing now...
Bye for Now,
Ian
\|||/
(o o)
/---------------------------ooO-(_)-Ooo---------------------------\
| Ian Chilton (IRC Nick - GadgetMan) ICQ #: 16007717 |
|-----------------------------------------------------------------|
| E-Mail: ian@ichilton.co.uk Web: http://www.ichilton.co.uk |
|-----------------------------------------------------------------|
| Budget: A method for going broke methodically. |
\-----------------------------------------------------------------/
