>>>>> "lejeczek" == lejeczek <peljasz@yahoo.co.uk> writes: lejeczek> On 17/10/17 21:57, Stuart D. Gathman wrote: >> You still haven't said what you are trying to accomplish. >> I wouldn't >> have bothered responding to such a vague question until >> you provided >> some tantalizing clues. Until your lastest clues, I would >> have advised >> using rsync or dd to copy your data to a new volume. But >> now it sounds >> like you ran out of budget for another disk, or need to >> minimize down >> time, and want to reconfigure in place. >> lejeczek> gee, with this much enthusiasm I can imagine you solve many lejeczek> problems, however I can also imagine at the same time you lejeczek> create also problems that do not exists. but honestly & lejeczek> truthfully appreciate this enthusiasm & help. Since you provided zero data on your configuration... what else do you expect? >> First off, raid10 is a linux specialty (I didn't know LVM >> supported it, >> thanks!), and is not the same as raid1+0 (raid1 on top of >> raid0). >> However, your previous clue tells us that probably you >> have at least 4 >> disks in your raid10. So you should be able to remove 2 >> legs from the >> raid10, and still have the equivalent of a raid0. But >> this is not >> certain as raid10 works perfectly well with 2 or 3 disks, >> including the >> redundancy. In any case, you can remove at least 1 leg >> from your >> raid10. Be sure to backup first in any case. >> >> Now that you've cut the disk used in half (and your data >> is precariously >> dependent on the health of *both* underlying physical >> disks), what did >> you want to do next? Maybe you just want to create a >> different kind of >> raid with the released space and do that rsync or dd? >> lejeczek> I'm still looking for an answer - if it's possible then how lejeczek> to split raid10 into two raid0 LVs(with perhaps having data lejeczek> intact?) I've been fiddling with --splitmirrors but either lejeczek> I got it wrong or I didn't and command just fails. More lejeczek> than contemplating theories and general knowledge on raid lejeczek> I'd prise a lot succinct, concrete info, actuall experience lejeczek> of "howto". Have you tried setting up some /dev/loop# devices and re-creating your setup on smaller devices and trying out various options? It sounds like you want to take an existing RAID10, remove half the disks (removing all redundancy) and then rebuilding into a new setup so you can move the data over? Even some simple examples of what you have and what you're trying to accomplish without showing your array names, etc would be a big help. lejeczek> But I shall now try my fiddling virtualized way, problem at lejeczek> hand I had, I had to solve different way completely. I can't make heads or tails of this. Sorry. _______________________________________________ linux-lvm mailing list linux-lvm@redhat.com https://www.redhat.com/mailman/listinfo/linux-lvm read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
