Thanks for the response Ken - I've been swamped, so appologies for the belated reply. On Fri, 6 Feb 2004 Ken Fuchs wrote: > The location of the extents of a logical volume can > have a great impact on its I/O performance: > > 1) LVM does its best to make the logical extents > physically contiguous, but pvmove(8) can be used to > improve this as the need arises. > > 2) Here's an often neglected fact: The performance of > the outer cylinders of almost any hard drive (larger > than a few GB) is usually about double that of the > inner cylinders of the same drive. Surely under hardware raid this doesn't apply, as the location of the data is mirrored/striped across many disks, so the physical location of data is no longer obvious? > 3) LVM striping can also be used to improve I/O > performance over two or more spindles (disks). > Avoid LVM striping over two physical volumes on > the same spindle (disk), since this reduces > performance as the system waits for seeks between > these two physical volumes (for a simple sequential > access). Now by using harware raid, theoretically there may well be an additional performance gain (increasing in proportion to the number of spindles of course). My original primary concern is the performance impact the system will experience, particularly if I append logical extents which are non-contiguous to a LV. Say for example, the original setup was: PEs(0-100) for LV /dev/mapper/v0-var-qmail-queue PEs (101-1000) for LV /dev/mapper/v0-home-mail And then I find at a later stage that my queue is too small, so append PEs (1001-1100) to the original LV /dev/mapper/v0-var-qmail-queue. Will the performance impact be noticeable, taking into consideration that each file written to the queue is synced, together with hardware raid and U320 SCSI disks? I know, it's difficult to assume things up-front, but I don't want to rush into using LVM for the wrong reasons... on that note, with hardware raid and the setup I posted originally, what are the clear practical benefits of using LVM, other than reducing the possible future need to sym-link directories onto other file- systems? I have LVM2/Linux-2.6.1 running on my laptop, but that's the only experience I have with LVM, so do not really know whether or not to go with it in a production environment, as I haven't the experience. Anyone care to enlighten me further? I'm not entirely convinced that LVM is the right way to go yet. Why _should_ I use it? Will the benefits out-weigh the negative aspects? Thanks. Dale _______________________________________________ linux-lvm mailing list linux-lvm@redhat.com https://www.redhat.com/mailman/listinfo/linux-lvm read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
