Hello.
On 2/23/2015 4:02 PM, Simon Guinot wrote:
On the LaCie 2Big Network v2 (net2big_v2) board, the fan alarm is not
wired to the I2C fan controller but to a separe GPIO. This GPIO can be
controlled by using the gpio-fan driver.
This patch adds the gpio-fan alarm description in the net2big_v2 DTS.
Signed-off-by: Simon Guinot <simon.guinot@xxxxxxxxxxxx>
---
arch/arm/boot/dts/kirkwood-net2big.dts | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/arch/arm/boot/dts/kirkwood-net2big.dts b/arch/arm/boot/dts/kirkwood-net2big.dts
index 53dc37a3b687..e4f7e497379f 100644
--- a/arch/arm/boot/dts/kirkwood-net2big.dts
+++ b/arch/arm/boot/dts/kirkwood-net2big.dts
@@ -27,6 +27,11 @@
device_type = "memory";
reg = <0x00000000 0x10000000>;
};
+
+ gpio_fan {
The ePAPR standard says that node name should be generic, so "fan" would
fit better here...
+ compatible = "gpio-fan";
+ alarm-gpios = <&gpio0 25 GPIO_ACTIVE_LOW>;
+ };
};
WBR, Sergei
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
