The NCT6775F and NCT6776F have specific temperature sensor resolutions for sensors above 3. Signed-off-by: Jean Delvare <khali@xxxxxxxxxxxx> Cc: Guenter Roeck <guenter.roeck@xxxxxxxxxxxx> --- Guenter, did I get it right? Documentation/hwmon/w83627ehf | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) --- linux-3.2-rc0.orig/Documentation/hwmon/w83627ehf 2011-10-31 17:00:50.000000000 +0100 +++ linux-3.2-rc0/Documentation/hwmon/w83627ehf 2011-11-01 10:55:03.000000000 +0100 @@ -62,8 +62,9 @@ sensors. The configured source for each in tempX_label. Temperatures are measured in degrees Celsius and measurement resolution is 1 -degC for temp1 and and 0.5 degC for temp2 and temp3. For temp4 and higher, -resolution is 1 degC for W83667HG-B and 0.0 degC for NCT6775F and NCT6776F. +degC for temp1 and and 0.5 degC for temp2 and temp3. For W83667HG-B, temp4 +has resolution 1 degC. For NCT6775F and NCT6776F, temp4 to temp6 have +resolution 0.5 degC, while temp7 to temp9 have resolution 1 degC. An alarm is triggered when the temperature gets higher than high limit; it stays on until the temperature falls below the hysteresis value. Alarms are only supported for temp1, temp2, and temp3. -- Jean Delvare _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors