On Mon, Jul 11, 2011 at 08:42:45AM -0400, Guenter Roeck wrote: > On Mon, Jul 11, 2011 at 04:53:09AM -0400, Jonathan Cameron wrote: > [ ... ] > > > > > > Based on this list, I suggest adding the following attributes to the ABI. > > > > > > in[0-*]_input_lowest > > > in[0-*]_input_highest > > > in[0-*]_average > > > in[0-*]_reset_history > > > > > > curr[1-*]_input_lowest > > > curr[1-*]_input_highest > > > curr[1-*]_average > > > curr[1-*]_reset_history > > > > > > temp[1-*]_input_lowest > > > temp[1-*]_input_highest > > > temp[1-*]_average > > > temp[1-*]_reset_history > > > > > > It might also be necessary to modify the sensors command to support both instantaneous > > > and average/peak power readings at the same time. > > How are you going to do peak power? > > > power already has > > power[1-*]_average > power[1-*]_input_highest > power[1-*]_input_lowest > power[1-*]_reset_history > > Also, turns out that the following attributes for current sensors already exist. > > curr[1-*]_average > curr[1-*]_lowest > curr[1-*]_highest > curr[1-*]_reset_history > curr_reset_history > Correction, the above existed for temperature sensors, and I added new attributes for voltage and current. Guenter _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
