Hi all, while adding support for more PMBus devices, I noticed that many of the chips support attributes which are not currently available in the sysfs ABI. Here is a (not necessarily complete) list. --- Historic minimum attributes: vout_min vin_min temp_min MAX34440 x MAX34441 x LTC2978 x x x Peak (historic maximum) attributes: pin_peak vin_peak vout_peak iout_peak temp_peak MAX34440 x x x MAX34441 x x x MAX8688 x x x MAX16064 x x ADM1275 x x x ADM1276 x x x x LTC2978 x x x LM25066 x (1) LM5064 x (1) LM5066 x (1) ZLxxxx (2) x (3) Average attributes: vin_avg vout_avg iin_avg pin_avg LM25066 x x x x (1) LM5064 x x x x (1) LM5066 x x x x (1) Notes: 1) In addition to instantaneous power measurements 2) All Intersil / Zilker Labs power management chips 3) Only available through SNAPSHOT command, which reads a total of 32 bytes. Also see Intersil / Zilker Labs AN2033. --- Based on this list, I suggest adding the following attributes to the ABI. in[0-*]_input_lowest in[0-*]_input_highest in[0-*]_average in[0-*]_reset_history curr[1-*]_input_lowest curr[1-*]_input_highest curr[1-*]_average curr[1-*]_reset_history temp[1-*]_input_lowest temp[1-*]_input_highest temp[1-*]_average temp[1-*]_reset_history It might also be necessary to modify the sensors command to support both instantaneous and average/peak power readings at the same time. Thoughts/comments ? Thanks, Guenter _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
