The alarm bit assumed to be a low voltage alarm bit is not set for low voltage
alarms, and the alarm bit assumed to be a high voltage alarm turns out to be a
general alarm bit which is set for both low and high voltage alarms.
Remove the in1_min_alarm sysfs attribute and rename in1_max_alarm to in1_alarm
to reflect the situation.
Signed-off-by: Guenter Roeck <guenter.roeck@xxxxxxxxxxxx>
---
drivers/hwmon/lineage-pem.c | 7 ++-----
1 files changed, 2 insertions(+), 5 deletions(-)
diff --git a/drivers/hwmon/lineage-pem.c b/drivers/hwmon/lineage-pem.c
index 2fe8e9e..ab63650 100644
--- a/drivers/hwmon/lineage-pem.c
+++ b/drivers/hwmon/lineage-pem.c
@@ -345,9 +345,7 @@ static ssize_t pem_show_fan(struct device *dev, struct device_attribute *da,
/* Voltages */
static SENSOR_DEVICE_ATTR(in1_input, S_IRUGO, pem_show_data, NULL,
PEM_DATA_VOUT_LSB);
-static SENSOR_DEVICE_ATTR_2(in1_min_alarm, S_IRUGO, pem_show_bool, NULL,
- PEM_DATA_ALARM_2, ALRM2_OV_LOW);
-static SENSOR_DEVICE_ATTR_2(in1_max_alarm, S_IRUGO, pem_show_bool, NULL,
+static SENSOR_DEVICE_ATTR_2(in1_alarm, S_IRUGO, pem_show_bool, NULL,
PEM_DATA_ALARM_1, ALRM1_VOUT_OUT_LIMIT);
static SENSOR_DEVICE_ATTR_2(in1_crit_alarm, S_IRUGO, pem_show_bool, NULL,
PEM_DATA_ALARM_1, ALRM1_OV_VOLT_SHUTDOWN);
@@ -395,8 +393,7 @@ static SENSOR_DEVICE_ATTR_2(temp1_fault, S_IRUGO, pem_show_bool, NULL,
static struct attribute *pem_attributes[] = {
&sensor_dev_attr_in1_input.dev_attr.attr,
- &sensor_dev_attr_in1_min_alarm.dev_attr.attr,
- &sensor_dev_attr_in1_max_alarm.dev_attr.attr,
+ &sensor_dev_attr_in1_alarm.dev_attr.attr,
&sensor_dev_attr_in1_crit_alarm.dev_attr.attr,
&sensor_dev_attr_in2_alarm.dev_attr.attr,
--
1.7.3.1
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
