On Mon, 2011-02-14 at 14:35 -0500, Guenter Roeck wrote: > The following patch series adds support for NCT6775F and NCT6776F to the > w83627ehf driver. It also includes some cleanup and adds support for > the fourth temperature sensor on W83677HG-B. > > v4: > - Store rpm instead of raw fan speed readings > - For NCT6775F, increase fan divisor if the fan speed reads 0 > [ On NCT6775F, fan speed readings can return 0 instead of 0xff if the > fan divisor value is too low ] > - Separate changes into more patches to simplify review > > v3: > - Documentation: Remove references to datasheets which no longer exist > - Documentation: Add information about limits of SmartFan IV support. > - SmartFan III mode is not supported on NCT6776F, so remove related attributes > and refuse to configure it. > - (additional patch) Improve support for chips with 16-bit fan count registers > > v2: > - W83677HG-B does share the AUXTIN/VIN3 pin, so we can not skip this check. > - Cosmetic changes to fix a couple of checkpatch errors and to undo some > unnecessary formatting changes in patch 5. > - Patch 1 introduced a bug in temp_to_reg which was fixed in a later patch. > Modified code to not introduce the bug in the first place. > - Two dev_dbg messages were changed to dev_info for testing. Changed back > to dev_dbg. > > The patched driver can be downloaded as stand-alone driver from > http://www.roeck-us.net/linux/drivers/w83627ehf/ Feedback, anyone ? Even if you don't have time to review the code, a "Tested-by" would be appreciated as well. Thanks, Guenter _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
