Here is a configure file that worked (to go with the new kernel module). It may not be perfect. inserted it as /etc/sensors.d/w83795ag.conf chip "w83795-*" label fan1 "Fan1" label fan2 "Fan2" label fan3 "Fan3" label fan4 "Fan4" label fan5 "Fan5" label fan6 "Fan6" label fan7 "fanignore" label fan8 "Fan8" label in0 "vCPU2" label in1 "vCPU1" label in3 "+5V" label in4 "+12V" label in5 "5vSB" label in6 "vcpu2dimm" label in7 "vcpu1dimm" label in11 "VTT" label in12 "+3.3V" label in13 "+3.3Vsb" label in14 "Vbatt" label temp5 "System temp" label temp7 "CPU1 temp" label temp8 "CPU2 temp" compute in3 @*(40/10), @/(40/10) compute in4 @*(10/66.2), @/(10/66.2) compute in5 @*(40/10), @/(40/10) chip "w83627hf-*" # SuperIO chip used only for the FDC, UARTs and GPIO # SENSORS ARE NOT WIRED # Power Supply Failure, GP31(From W83627DHG-P) 1 = Good, 0 = Bad ignore fan1 ignore fan2 ignore fan3 ignore fan4 ignore fan5 ignore temp1 ignore temp2 ignore temp3 ignore in0 ignore in1 ignore in2 ignore in3 ignore in4 ignore in5 ignore in6 ignore in7 ignore in8 ignore cpu0_vid Thanks again. David Anderson _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
