Please add this to the lm-sensors wiki, and any relevant userspace config files being shipped in lm-sensors userspace. The BIOS does not set the correct limits for VTT, but it is wired. I still haven't found how the PWM outputs are wired in this board, though, due to my mix of PWM and non-PWM fans I cannot enable fan control. -- "One disk to rule them all, One disk to find them. One disk to bring them all and in the darkness grind them. In the Land of Redmond where the shadows lie." -- The Silicon Valley Tarot Henrique Holschuh
# # Data for SuperMicro C7X58 and X8SAX boards, revision 1.1 or 2.0 # Scaling factors kindly provided by SuperMicro support. # # Board has two sensor chips, w83627dhg is not used for temperature, # fans or voltage sensing. BIOS allows one to set w83795adg # parameters, such as voltage or PWM fan control and default strategy. # chip "w83795adg-*" label fan1 "CPU Fan" label in0 "CPU Core" label in2 "DIMM" label in3 "+5V" label in4 "+12V" label in5 "-12V" label in11 "VTT" label in12 "+3.3V" label in13 "+3.3Vsb" label in14 "Vbatt" label temp6 "System temperature" label temp7 "CPU temperature" compute in3 @*4, @/4 compute in4 @*6.62, @/6.62 compute in5 (@-2.048)*24.2 + 2.048, ((@-2.048)/24.2)+2.048 chip "w83627dhg-*" # SuperIO chip used only for the FDC, UARTs and GPIO # SENSORS ARE NOT WIRED # Power Supply Failure, GP31(From W83627DHG-P) 1 = Good, 0 = Bad ignore fan1 ignore fan2 ignore fan3 ignore fan4 ignore fan5 ignore temp1 ignore temp2 ignore temp3 ignore in0 ignore in1 ignore in2 ignore in3 ignore in4 ignore in5 ignore in6 ignore in7 ignore in8 ignore cpu0_vid
_______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
