This patch set has earlier been sent to lm-sensors list (thus patch v2). No changes after that except to patch 0006 to make it applicable to 2.6.32-rc6 (no functional changes). There has been discussion on lm-sensors list about the patch "lis3: Scale output values to mg (0009)". It causes changes to existing user space applications. See link below about this discussion: http://lists.lm-sensors.org/pipermail/lm-sensors/2009-November/027101.html Patches are applicable to top of 2.6.32-RC6. This patch set makes several changes to the lis3 accelerometer chip family driver. There are also two patches from Eric Piel. I have possibility to test these changes only with 8 bit version (lis302d). Since part of the changes are specific to 12 bit device, I would appreciate if someone could try these on 12 bit device. 0001: Sync event is sent after each measurement. This helps user space applications to detect which 3 reported values belongs to one atomic measurement. 0002: polled input device was not totally released in module unload. This corrects memory leak. 0003: This patch is originally from Eric Piel. Updates documentation and chip ID handling 0004: This patch is originally from Eric Piel. Correction to sampling rate handling for 8 bit devices 0005: Chip power on sequence was not waiting for chip to be ready. This caused incorrect values right after the power on. 0006: Chip specifications contains selftest for the chip. This patch implements that. 0007: Calibration functionality is removed from the driver. Chip is allready calibrated by the manufacturer. SW calibration doesn't improve the situation. 0008: Added possibility to set chip sampling rate. Position entry in sysfs allows reading at sampling rate. 0009: Scale output values to mg (1/1000 of earth gravity). (see comments above) 0010: Updates documentation Samu Onkalo (8): LIS3LV02D: Send sync event LIS3LV02D: Correct memory leak in module unload LIS3LV02D: Proper power on sequence LIS3LV02D: Selftest support LIS3LV02D: Remove calibaration functionality lis3: Sysfs entry for setting chip measurement rate lis3: Scale output values to mg LIS3: Update documentation to match latest changes Ã?ric Piel (2): lis3: Update documentation and comments lis3: fix show rate for 8 bits chips Documentation/hwmon/lis3lv02d | 40 ++++--- drivers/hwmon/Kconfig | 22 ++-- drivers/hwmon/lis3lv02d.c | 234 +++++++++++++++++++++++++++++++---------- drivers/hwmon/lis3lv02d.h | 48 ++++++--- include/linux/lis3lv02d.h | 2 + 5 files changed, 249 insertions(+), 97 deletions(-)
_______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
