Hi, I am somewhat of a Linux newbie and was finally able to figure out what I needed to get lm-sensors installed and working...sort of. Now, when I type "sensors" at a terminal window command prompt, it gives me the values once and then goes back to the command prompt. Shouldn't it continue to monitor and not go back to the command prompt until I terminate the sensors program??? Regards, Bill Nackers Technical Service Engineer Support Hours: 8AM-6PM Eastern Time, Monday-Friday TRENTON Phone: (800) 875-6031 (770) 287-3100 E-mail: <mailto:wbnackers at TrentonTechnology.com> bnackers at TrentonTechnology.com Web: <http://www.trentontechnology.com/> www.TrentonTechnology.com Follow us: <http://www.twitter.com/TrentonTech> www.Twitter.com/TrentonTech ____________________________________________________________________________ __________________________ This electronic mail message and any attachment(s) contain information intended for the exclusive use of the party to whom it is addressed and may contain information that is proprietary, privileged, confidential, and/or exempt from disclosure. If you are not the intended recipient, you are hereby notified that any viewing, copying, disclosure or distribution of this information is prohibited. If you believe this message was sent to you in error, please immediately notify the sender by reply e-mail and delete this message from your computer system without disclosing it. Thank you. ____________________________________________________________________________ __________________________ -------------- next part -------------- An HTML attachment was scrubbed... URL: http://lists.lm-sensors.org/pipermail/lm-sensors/attachments/20090709/19031c78/attachment.html