Hi Joakim, On Thu, 13 Mar 2008 19:44:08 +0100, Joakim Larsson wrote: > thanks for the hint, Ubuntu Feisty uses lm-sensors 2.10.1 So I compiled > and installed the latest version (3.0.1) and starts to get some results > from sensor, see below. I will go through the configuration now and > figure out why the fan still sounds like my vacuum cleaner. > > BR > > Joakim > > > joakim at montecristo:~$ sensors -v > sensors version 3.0.1 with libsensors version 3.0.1 > joakim at montecristo:~$ sensors > w83627dhg-isa-0290 > Adapter: ISA adapter > VCore: +1.35 V (min = +0.00 V, max = +1.74 V) > in1: +12.46 V (min = +6.39 V, max = +0.90 V) ALARM Probably +12V > AVCC: +3.28 V (min = +0.54 V, max = +2.05 V) ALARM > 3VCC: +3.28 V (min = +0.66 V, max = +0.00 V) ALARM > in4: +1.86 V (min = +1.07 V, max = +0.39 V) ALARM > in5: +1.46 V (min = +1.02 V, max = +0.06 V) ALARM > in6: +5.04 V (min = +2.59 V, max = +4.12 V) ALARM and +5V. If your system uses DDR2 SDRAM, in4 could be Vdimm. in5 could be Vagp. If I'm right, you can add the following lines to the w83627dhg-* section in /etc/sensors3.conf: label in1 "+12V" label in4 "Vdimm" label in5 "Vagp" label in6 "+5V" > VSB: +3.28 V (min = +0.02 V, max = +1.60 V) ALARM > VBAT: +3.09 V (min = +1.58 V, max = +0.32 V) ALARM To get rid of the alarms, uncomment the "set in*" statements, adjust the limits as needed (typically -10% and +10% of the nominal value), and run "sensors -s". > Case Fan: 0 RPM (min = 376 RPM, div = 64) ALARM > CPU Fan: 2481 RPM (min = 2109 RPM, div = 16) > Aux Fan: 1298 RPM (min = 439 RPM, div = 16) > fan4: 0 RPM (min = 8881 RPM, div = 4) ALARM > fan5: 0 RPM (min = 10227 RPM, div = 4) ALARM I guess that you have only 2 fans in this system, so you can add: ignore fan1 ignore fan4 ignore fan5 And change fan3's label: label fan3 "Case Fan" These are very reasonable fan speeds and I have to admit that I am surprised the one the fans "sounds like your vacuum cleaner". > Sys Temp: +37.0?C (high = +0.0?C, hyst = +16.0?C) ALARM sensor = thermistor > CPU Temp: +18.0?C (high = +110.0?C, hyst = +125.0?C) sensor = diode > AUX Temp: +64.0?C (high = +120.0?C, hyst = +115.0?C) sensor = thermistor While temp1 and temp3 look reasonable, temp2 is way too low to be correct. What does the BIOS display? Maybe you need to add some arbitrary offset. -- Jean Delvare
