On Fri, 14 Dec 2007 16:01:09 +0100, Udo van den Heuvel wrote: > Jean Delvare wrote: > > This leaves temp1 and temp2 for the CPU and system temperatures, or > > vice-versa. Usually the CPU uses a thermal diode and the system a > > thermistor so it's easy to tell them apart, but in your case these are > > two thermistors. To find out which is which, just run a CPU-intensive > > task and check which temperature is rising faster - that will be the > > CPU sensor. And the other one is the system temperature sensor. > > temp2 appears to be getting the hottest, so should be CPU. > Anyone able to confirm this for a Gigabyte M56S-S3 board? > > > > > If you come up with a good configuration file for that board, please > > submit it and we'll add it to our collection. > > > > Ok, current working config for M56S-S3 board: > > chip "it8716-*" > > # Voltages > > label in0 "VCore" > label in1 "VDDR" > label in2 "+3.3V" # VCC3 > label in3 "+5V" # VCC > label in4 "+12V" > # label in5 "unknown" # need input on function > ignore in6 > label in7 "5VSB" # VCCH > label in8 "VBat" > > compute in3 ((6.8/10)+1)*@ , @/((6.8/10)+1) > compute in4 ((30/10)+1)*@ , @/((30/10)+1) > # compute in5 (1+232/56)*@ - 4.096*232/56 , (@ + 4.096*232/56)/(1+232/56) > # compute in6 (1+120/56)*@ - 4.096*120/56 , (@ + 4.096*120/56)/(1+120/56) > compute in7 ((6.8/10)+1)*@ , @/((6.8/10)+1) > > # Temperatures > > # If you are lucky, the BIOS has set the proper sensor types for you. > # If your temperature readings are completely whacky you probably > # need to change the sensor types. Adujst and uncomment the > # appropriate lines below. > # > # 2 = thermistor; 3 = thermal diode; 0 = unused > set sensor1 2 > set sensor2 2 > set sensor3 3 Did you have to overwrite the BIOS values here? If not, better omit the set statements... > > # If a given sensor isn't used, you will probably want to ignore it > # as well (see ignore statement right below). > # The CPU sensor can be any of temp1, temp2 or temp3 - it's motherboard > # dependent. Same for the motherboard temperature. > > label temp2 "CPU Temp" > label temp1 "M/B Temp" > ignore temp3 ... especially if you're going to ignore the sensor in question. > > set temp1_over 50 > set temp1_low 10 > set temp2_over 60 > set temp2_low 10 > > # Fans > > # The CPU fan can be any of fan1, fan2 or fan3 - it's motherboard > # dependent. Same for the case fan. > > label fan1 "CPU Fan" > label fan2 "Case Fan" > -- Jean Delvare