David, I emailed Margit, but have not received a reply. There must be something goofy with this and I cannot point to it. My inclination will be that something in the hardware, as the software has not changed for the results I have. This unit has a ADT7463 chip on it. I did a test to see if the BIOS based fan and temperature controls were working right. The fans that fails is #3, one of the 2 CPU fans. Fans #1 which is left to #3 is working perfectly. So is fan #1 in the back of the unit. I changed the pwm for fan #1 and set it to 255 and rpms go up to like 13K. The temp of the cpu goes down and so the other two sensors for local and sys temp. I had it running like this for about 5 min and I was expecting fan #3 to go down in rpms as a result, but nothing. It stayed at the very same rpm. Then I ran fancontrol and all 3 fans respond to it, with the exception that with the other 2 fans, the moment you change pwm it has a direct correlation. I normally have pwm set at 64 or 32 which is more than adequate for temperature control. I can set fan #3 to pwm of 3 and it does not come down from 9400 rpms or so. If I do this to the other 2 fans they will probably stop of come very close to it. Is like the response curve for pwm is not the same for fan #3 and the other 2 fans. So, I don't know what is causing this, but is very irritating the noise this units make. Could sensors be causing some corruption like with the thinkpads in some memory or register? Is the fact that the other 2 fans work perfectly and #3 does not an indication of bad hardware? Regards, Paul Aviles
