fred a ?crit :
> Hi,
>
> My kernel is 2.6.14, i2c-nforce2 & it87, which are known to work
> with lm-sensors, are built-in kernel, on a Debian sarge.
>
> it87 works fine (I'll come back later on this, I have a few questions),
> but i2c-nforce2 fails :
> marsu{pts/0}:~/[1]/> i2cdetect
> Error: No i2c-bus specified!
> Syntax: i2cdetect [-y] [-a] [-q|-r] I2CBUS [FIRST LAST]
> i2cdetect -l
> i2cdetect -V
> I2CBUS is an integer
> With -a, probe all addresses (NOT RECOMMENDED)
> With -q, uses only quick write commands for probing (NOT RECOMMENDED)
> With -r, uses only read byte commands for probing (NOT RECOMMENDED)
> If provided, FIRST and LAST limit the probing range.
> With -l, lists installed busses only
> Error: No I2C busses found!
> Be sure you have done 'modprobe i2c-dev'
> and also modprobed your i2c bus drivers
>
> My kernel is set as :
>
> CONFIG_I2C=y
> CONFIG_I2C_CHARDEV=y
> CONFIG_I2C_ALGOBIT=y
> CONFIG_I2C_ISA=y
> CONFIG_I2C_NFORCE2=y
> CONFIG_FB_NVIDIA_I2C=y (for framebuffer, but now, it's not the problem)
>
>
> What's wrong ??
And lspci sounds good :
0000:00:0a.0 ISA bridge: nVidia Corporation: Unknown device 0030 (rev a3)
Subsystem: Asustek Computer, Inc.: Unknown device 818a
Flags: bus master, 66MHz, fast devsel, latency 0
0000:00:0a.1 SMBus: nVidia Corporation: Unknown device 0034 (rev a2)
Subsystem: Asustek Computer, Inc.: Unknown device 818a
Flags: 66MHz, fast devsel, IRQ 3
I/O ports at e400 [size=32]
I/O ports at 5000 [size=64]
I/O ports at 5100 [size=64]
Capabilities: <available only to root>
--
Fred.
