On Wed, May 18, 2005 at 03:28:23AM -0400, Yani Ioannou wrote: > Hi Greg, > > On 5/18/05, Greg KH <greg at kroah.com> wrote: > > Ok, I think I got all of these patches applied properly (hint, don't > > label your intro message as 1/15, it should be 0/14, with 14 different > > patches, that threw me off for a bit.) I've also included your i2c > > driver patch for the adm1026 driver only. All of these patches are now > > in my tree and can be found on kernel.org in the place where my > > patchscripts notified you. If you could verify them I would appreciate > > it (I also added a few patches for stuff that was in my tree only, like > > new i2c drivers and some usb and pci sysfs stuff to make them build > > properly.) All of this should show up in the next -mm release too. > > Thanks a lot! Sorry about the incorrect numbering, first time I've > done an intro. I'll have to send you a patch against the differences > between 2.6.12-rc4 and 2.6.12-rc4-mm2 so we don't run into a huge > amount of trouble when they merge... That would be good. > A quick glance through everything looks fine, but I'll do a proper > check tomorrow using your git tree. I don't have a git tree for stuff that is not ready to be sent to Linus at that moment. I'm using quilt to stage stuff and have them be sucked into the -mm releases. It's easier that way for me right now. thanks, greg k-h _______________________________________________ lm-sensors mailing list lm-sensors at lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
