Hi. I have this problem: ==== i2c-piix4.o: IBM Laptop detected; this module may corrupt your serial eeprom! Refusing to load module! ==== And I have read this message: #### http://archives.andrew.net.au/lm-sensors/msg01833.html #### Is my PC on your "whitelist", please? Thanks a lot Tomas Thiemel ICQ #170438916 http://www.wifizabreh.net PS: What means "serial eeprom" - is it "BIOS chip"? ------------------------------ See information listed below: ***lspci -v *** .. 00:02.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 02) Flags: medium devsel, IRQ 9 .. ***lspci -n*** 00:00.0 Class 0600: 8086:7190 (rev 03) 00:01.0 Class 0604: 8086:7191 (rev 03) 00:02.0 Class 0601: 8086:7110 (rev 02) 00:02.1 Class 0101: 8086:7111 (rev 01) 00:02.2 Class 0c03: 8086:7112 (rev 01) 00:02.3 Class 0680: 8086:7113 (rev 02) 00:03.0 Class 0200: 8086:1229 (rev 05) 00:12.0 Class 0280: 1260:3873 (rev 01) 00:14.0 Class 0280: 1260:3873 (rev 01) 01:01.0 Class 0300: 5333:8904 (rev 01) ***cat /var/log/dmesg*** Linux version 2.4.29 (root at wifizabreh2) (gcc version 3.2.2 20030222 (Red Hat Linux 3.2.2-5)) #12 22:57:14 CEST 07-04-2005 127MB LOWMEM available. .. IBM machine detected. Enabling interrupts during APM calls. Kernel command line: ro root=/dev/hda1 No local APIC present or hardware disabled Initializing CPU#0 Detected 398.272 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 794.62 BogoMIPS Memory: 126864k/131060k available (1508k kernel code, 3808k reserved, 541k data, 100k init, 0k highmem) .. CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: 0183f9ff 00000000 00000000 00000000 CPU: Common caps: 0183f9ff 00000000 00000000 00000000 CPU: Intel Pentium II (Deschutes) stepping 02 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch at atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfd85c, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Using IRQ router PIIX/ICH [8086/7110] at 00:02.0 Limiting direct PCI/PCI transfers. isapnp: Scanning for PnP cards... isapnp: Card 'Crystal Audio' isapnp: 1 Plug & Play card detected total Linux NET4.0 for Linux 2.4 .. Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller at PCI slot 00:02.1 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xfff0-0xfff7, BIOS settings: hda:DMA, hdb:pio hda: Maxtor 90644D3, ATA DISK drive blk: queue c0346500, I/O limit 4095Mb (mask 0xffffffff) ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ..
