Hello, I am attempting to hack together a 2.6 port of the GL520SM chip driver. I am a little confused as to the relationship between temp2_input, and vin4_input values. The way I understand it, the GL520SM can either be configured to monitor ambient temperature, or the 4th voltage input. This is done by setting/unsetting the 4th bit of the config register. However when I set the mode bit, the value of the temp2_input register does not change. I would have expected it to switch over to the vin4_input reading, and not remain the exact same value. Also the alarms do not trigger when the mode bit is set, and vin4_input is out of range of vin4_max, and vin4_min. Is there some kind of reset I have to do on the chip other than just setting the mode bit? Regards, Daniel
