From: "E. Reijenga [bash bv]" <eltjo at bash.nl> > DeBeheerder StationeryRE: ticket 756, > http://www2.lm-sensors.nu/~lm78/readticket.cgi?ticket=756 > > Hi, > > I'm experiencing the same problem. > > Is there a solution jet? > >From looking at the ticket the default is 0x2a is 101010 or 101 010, temp sensors 3,1 thermister, 2 diode modprobe it87 temp_type=0x31 0x31 is 110001 or 110 001, temp sensors 3,2 thermister, 1 diode so this does change the type of sensor for temperature 1 which is why it stops working. I think you want 111 000 modprobe it87 temp_type=0x38 Same as http://www2.lm-sensors.nu/~lm78/readticket.cgi?ticket=757 >From data sheet 9.5.3.2.28 ADC Temperature Channel Enable Register (Index=51h, Default=00h) TMPIN3-1 cannot be enabled in both Thermal Register mode and Thermal Diode (Diode connected Transistor) mode. Bit R/W Description 7-6 R/W Reserved 5-3 R/W TMPIN3-1 are enabled in Thermal Resistor mode 2-0 R/W TMPIN3-1 are enabled in Thermal Diode (or Diode-connected Transistor) mode David Gesswein http://www.pdp8.net/ -- Run an old computer with blinkenlights
