Hello,
I'm trying to get serveral lm_sensor versions up to CVS lm_sensors2 from
yesterday to run on this mb. Now, I'm at linux-2.4.15-pre4, but also tried
some 2.4.12(-ac?) versions, to no avail.
sensors-detect says:
We can start with probing for (PCI) I2C or SMBus adapters.
You do not need any special privileges for this.
Do you want to probe now? (YES/no):
Probing for PCI bus adapters...
Use driver `i2c-amd756' for device 00:07.3: AMD-766 Athlon ACPI
Probe succesfully concluded.
We will now try to load each adapter module in turn.
Module `i2c-amd756' already loaded.
Do you now want to be prompted for non-detectable adapters? (yes/NO):
To continue, we need module `i2c-dev' to be loaded.
If it is built-in into your kernel, you can safely skip this.
i2c-dev is already loaded.
We are now going to do the adapter probings. Some adapters may hang halfway
through; we can't really help that. Also, some chips will be double detected;
we choose the one with the highest confidence value in that case.
If you found that the adapter hung after probing a certain address, you can
specify that address to remain unprobed. That often
includes address 0x69 (clock chip).
Next adapter: SMBus AMD7X6 adapter at 80e0 (Non-I2C SMBus adapter)
Do you want to scan it? (YES/no/selectively):
Client found at address 0x08
Probing for `National Semiconductor LM78'... Failed!
Probing for `National Semiconductor LM78-J'... Failed!
Probing for `National Semiconductor LM79'... Failed!
Probing for `Winbond W83781D'... Failed!
Probing for `Winbond W83782D'... Failed!
Probing for `Winbond W83783S'... Failed!
Probing for `Winbond W83627HF'... Failed!
Probing for `Asus AS99127F'... Failed!
Client found at address 0x2d
Probing for `Myson MTP008'... Failed!
Probing for `National Semiconductor LM78'... Failed!
Probing for `National Semiconductor LM78-J'... Failed!
Probing for `National Semiconductor LM79'... Failed!
Probing for `National Semiconductor LM80'... Failed!
Probing for `National Semiconductor LM87'... Failed!
Probing for `Winbond W83781D'... Failed!
Probing for `Winbond W83782D'... Success!
(confidence 8, driver `w83781d'), other addresses: 0x48 0x49
[eeprom stuff removed]
Probed modules:
# I2C adapter drivers
modprobe i2c-amd756
# I2C chip drivers
modprobe w83781d <---- FREEZE
kernel log during sensors-detect:
Nov 14 17:28:33 tyrex kernel: i2c-core.o: i2c core module
Nov 14 17:28:33 tyrex kernel: i2c-amd756.o version 2.6.1 (20010830)
Nov 14 17:28:33 tyrex kernel: i2c-core.o: adapter SMBus AMD7X6 adapter at
80e0 registered
as adapter 0.
Nov 14 17:28:33 tyrex kernel: i2c-amd756.o: AMD756/766 bus detected and
initialized
Nov 14 17:28:38 tyrex kernel: i2c-dev.o: i2c /dev entries driver module
Nov 14 17:28:38 tyrex kernel: i2c-core.o: driver i2c-dev dummy driver
registered.
Nov 14 17:28:38 tyrex kernel: i2c-dev.o: Registered 'SMBus AMD7X6 adapter at
80e0' as minor 0
Nov 14 17:28:49 tyrex kernel: i2c-amd756.o: SMBus collision!
Nov 14 17:28:49 tyrex last message repeated 3 times
Any suggestions?
Hans-Peter
