Hi Stefan, > With the version 0.3 for the ATUSB firmware finally out of the door here are the > corresponding kernel driver patches to make use of the new functionality. > > While the first to patches are just preparation the last two are useful enhancements. An permanent > EUI64 address can now be hold in the EEPROM of the ATUSB dongle to survive reboots and allowing a > unique identification and no need to mess around with generated addresses after each device probe. > > All new ATUSB dongles will have a address set in EEPROM already, for devices that are out in the > wild already you would have to ask me to assign you an official one if you want it. Feel free to do > so. :) > > The last one allows to set the maximal fram reties values now that we support the needed states > inside the firmware. This finishes the hardware assisted ACK handling on the TX site. RX side was > working for a long time already. > > Stefan Schmidt (4): > ieee802154: atusb: sync header file from firmware for new features > ieee802154: atusb: store firmware version after retrieval for later > use > ieee802154: atusb: try to read permanent extended address from device > ieee802154: atusb: implement .set_frame_retries ops callback > > drivers/net/ieee802154/atusb.c | 79 ++++++++++++++++++++++++++++++++++++++---- > drivers/net/ieee802154/atusb.h | 11 ++++-- > 2 files changed, 80 insertions(+), 10 deletions(-) all 4 patches have been applied to bluetooth-next tree. Regards Marcel -- To unsubscribe from this list: send the line "unsubscribe linux-wpan" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html