Whenever both WLAN and BT in/out sleep mode, sometimes WLAN is not able to take back the shared LNA control after resumes from sleep mode. The idea is that for WLAN to check if BT owns LNA control and BT is in sleep mode when WLAN just resumes from sleep mode. If the condition is true, do a BTCOEX_RC_WARM_RESET for WLAN to take back the control of shared LNA. Now the issue is the BT sleep value read from MCI register is overlooked by assigning u32 into u8. Hence the above condition never be met so that WLAN used to report beacon losses and frequent connection drops. Signed-off-by: Rajkumar Manoharan <rmanohar@xxxxxxxxxxxxxxxx> --- drivers/net/wireless/ath/ath9k/ar9003_mci.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/net/wireless/ath/ath9k/ar9003_mci.c b/drivers/net/wireless/ath/ath9k/ar9003_mci.c index cab2384..d3fae36 100644 --- a/drivers/net/wireless/ath/ath9k/ar9003_mci.c +++ b/drivers/net/wireless/ath/ath9k/ar9003_mci.c @@ -1410,7 +1410,7 @@ void ar9003_mci_set_power_awake(struct ath_hw *ah) } REG_WRITE(ah, AR_DIAG_SW, (diag_sw | BIT(27) | BIT(19) | BIT(18))); lna_ctrl = REG_READ(ah, AR_OBS_BUS_CTRL) & 0x3; - bt_sleep = REG_READ(ah, AR_MCI_RX_STATUS) & AR_MCI_RX_REMOTE_SLEEP; + bt_sleep = MS(REG_READ(ah, AR_MCI_RX_STATUS), AR_MCI_RX_REMOTE_SLEEP); REG_WRITE(ah, AR_BTCOEX_CTRL2, btcoex_ctrl2); REG_WRITE(ah, AR_DIAG_SW, diag_sw); -- 1.7.12.1 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
