Hi Hans, mwifiex AP functionality has been tested against following hostapd revision: http://hostap.epitest.fi/gitweb/gitweb.cgi?p=hostap.git;a=snapshot;h=5f32f79c6e071f02076e09931adc8fc4e0ecd383;sf=tgz Can you please test mwifiex AP setup against this hostapd revision and let me know result? Regards, Avinash On Thu, Jun 7, 2012 at 3:53 PM, Hans Kröner <hanskroner@xxxxxxxxx> wrote: > Hi Avinash, > > Thanks for your reply! > > i) Firmware version is reported as "mwifiex 1.0 (14.57.5.p69)" > > ii) hostapd version is "v2.0-devel" I took it from git at > git://w1.fi/srv/git/hostap.git and used the config in my previous post > to build it. I'm at commit 5b3763336466f2c55611437cb924aeee45f7203e > > iii) Output of hostapd "-ddd" is the same as my previous post, which used > "-dd". Here it is: > > random: Trying to read entropy from /dev/random > Configuration file: hostapd-minimal.conf > nl80211: interface uap0 in phy phy0 > rfkill: initial event: idx=0 type=2 op=0 soft=0 hard=0 > rfkill: initial event: idx=1 type=1 op=0 soft=0 hard=0 > nl80211: Disable use_monitor with device_ap_sme since no monitor mode > support detected > nl80211: Add own interface ifindex 5 > nl80211: Set mode ifindex 5 iftype 3 (AP) > nl80211: Setup AP - device_ap_sme=1 use_monitor=0 > nl80211: Subscribe to mgmt frames with AP handle 0x74608 (device SME) > nl80211: Register frame type=0xd0 nl_handle=0x74608 > nl80211: Register frame match - hexdump(len=0): [NULL] > nl80211: Register frame command failed (type=208): ret=-95 (Operation not > supported) > nl80211: Register frame match - hexdump(len=0): [NULL] > nl80211: Failed to set interface uap0 into AP mode > netlink: Operstate: linkmode=0, operstate=6 > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Try mode change after setting interface down > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Set mode ifindex 5 iftype 2 (STATION) > nl80211: Failed to set interface 5 to mode 2: -16 (Device or resource busy) > nl80211: Interface mode change to 2 from 3 failed > nl80211 driver initialization failed. > > Thanks for your help!!! > > Best Regards, > > Hans > > -- > To unsubscribe from this list: send the line "unsubscribe linux-wireless" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
