After a chip reset, the beacon timers have to re-programmed
correctly for a station in associated state. Use the PS flags
to ensure that this is done after a TSF sync happens, otherwise
the driver ends up using incorrect values for TBTT/DTIM in
powersave mode.
Signed-off-by: Sujith Manoharan <c_manoha@xxxxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath9k/main.c | 14 ++++++++++++--
1 file changed, 12 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c
index 953888b..0a9ef9e 100644
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
@@ -210,6 +210,7 @@ static bool ath_complete_reset(struct ath_softc *sc, bool start)
{
struct ath_hw *ah = sc->sc_ah;
struct ath_common *common = ath9k_hw_common(ah);
+ unsigned long flags;
if (ath_startrecv(sc) != 0) {
ath_err(common, "Unable to restart recv logic\n");
@@ -224,9 +225,18 @@ static bool ath_complete_reset(struct ath_softc *sc, bool start)
ath9k_hw_enable_interrupts(ah);
if (!(sc->hw->conf.flags & IEEE80211_CONF_OFFCHANNEL) && start) {
- if (test_bit(SC_OP_BEACONS, &sc->sc_flags))
- ath_set_beacon(sc);
+ if (!test_bit(SC_OP_BEACONS, &sc->sc_flags))
+ goto work;
+
+ ath_set_beacon(sc);
+ if (ah->opmode == NL80211_IFTYPE_STATION &&
+ test_bit(SC_OP_PRIM_STA_VIF, &sc->sc_flags)) {
+ spin_lock_irqsave(&sc->sc_pm_lock, flags);
+ sc->ps_flags |= PS_BEACON_SYNC | PS_WAIT_FOR_BEACON;
+ spin_unlock_irqrestore(&sc->sc_pm_lock, flags);
+ }
+ work:
ath_restart_work(sc);
}
--
1.7.10.3
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
