On Wed, Nov 23, 2011 at 09:51:38AM +0100, Helmut Schaa wrote: > Are we 100% sure that the rt2800pci device is generating the interrupts? No, good point. There is also usb_hcd_irq() registered on that line. I wonder if there is method to control irq routing. I don't know about any that could allow to control assignment of individual irq's. There are nomsi, acpi=noirq and noacpi kernel parameters which influence irq routing, so perhaps with a bit of luck they could cause exclusively Ralink device will be assigned to irq line> Amir, could you configure system to assure Ralink device have assigned exclusive (non shared) irq line. Interrupts assignment can be seen in /proc/interrupts. If above kernel parameters do not achieve that, you can try disabling USB in BIOS and (if possible) changing pci slot of Ralink device. > Just a shot in the dark but instead of masking out interrupts we don't handle > just enable all device interrupts. Mind to try the below patch? Amir, the best way is to test it on top of compat wireless, if you will be unable to do this, I'll prepare fedora koji build with patch. Thanks Stanislaw > --- > diff --git a/drivers/net/wireless/rt2x00/rt2800pci.c > b/drivers/net/wireless/rt2x00/rt2800pci.c > index 4dc2d0f..c0badec 100644 > --- a/drivers/net/wireless/rt2x00/rt2800pci.c > +++ b/drivers/net/wireless/rt2x00/rt2800pci.c > @@ -437,24 +437,24 @@ static void rt2800pci_toggle_irq(struct > rt2x00_dev *rt2x00dev, > > spin_lock_irqsave(&rt2x00dev->irqmask_lock, flags); > rt2x00pci_register_read(rt2x00dev, INT_MASK_CSR, ®); > - rt2x00_set_field32(®, INT_MASK_CSR_RXDELAYINT, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_TXDELAYINT, 0); > + rt2x00_set_field32(®, INT_MASK_CSR_RXDELAYINT, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_TXDELAYINT, mask); > rt2x00_set_field32(®, INT_MASK_CSR_RX_DONE, mask); > - rt2x00_set_field32(®, INT_MASK_CSR_AC0_DMA_DONE, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_AC1_DMA_DONE, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_AC2_DMA_DONE, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_AC3_DMA_DONE, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_HCCA_DMA_DONE, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_MGMT_DMA_DONE, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_MCU_COMMAND, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_RXTX_COHERENT, 0); > + rt2x00_set_field32(®, INT_MASK_CSR_AC0_DMA_DONE, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_AC1_DMA_DONE, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_AC2_DMA_DONE, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_AC3_DMA_DONE, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_HCCA_DMA_DONE, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_MGMT_DMA_DONE, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_MCU_COMMAND, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_RXTX_COHERENT, mask); > rt2x00_set_field32(®, INT_MASK_CSR_TBTT, mask); > rt2x00_set_field32(®, INT_MASK_CSR_PRE_TBTT, mask); > rt2x00_set_field32(®, INT_MASK_CSR_TX_FIFO_STATUS, mask); > rt2x00_set_field32(®, INT_MASK_CSR_AUTO_WAKEUP, mask); > - rt2x00_set_field32(®, INT_MASK_CSR_GPTIMER, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_RX_COHERENT, 0); > - rt2x00_set_field32(®, INT_MASK_CSR_TX_COHERENT, 0); > + rt2x00_set_field32(®, INT_MASK_CSR_GPTIMER, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_RX_COHERENT, mask); > + rt2x00_set_field32(®, INT_MASK_CSR_TX_COHERENT, mask); > rt2x00pci_register_write(rt2x00dev, INT_MASK_CSR, reg); > spin_unlock_irqrestore(&rt2x00dev->irqmask_lock, flags); -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
