On Thu, 2011-08-25 at 12:51 +0300, Arik Nemtsov wrote: > When this flag is set, Tx aggregations will not be initiated even > if the hardware supports A-MPDU aggregation in general. This flag > is required for devices supporting (partial) software Rx-aggregation. > > Signed-off-by: Arik Nemtsov <arik@xxxxxxxxxx> > --- > include/net/mac80211.h | 4 ++++ > net/mac80211/agg-tx.c | 3 ++- > net/mac80211/debugfs.c | 2 ++ > net/mac80211/tx.c | 3 ++- > 4 files changed, 10 insertions(+), 2 deletions(-) > > diff --git a/include/net/mac80211.h b/include/net/mac80211.h > index 2f01d84..b21a5bb 100644 > --- a/include/net/mac80211.h > +++ b/include/net/mac80211.h > @@ -1094,6 +1094,9 @@ enum sta_notify_cmd { > * stations based on the PM bit of incoming frames. > * Use ieee80211_start_ps()/ieee8021_end_ps() to manually configure > * the PS mode of connected stations. > + * > + * @IEEE80211_HW_TX_AMPDU_IN_HW_ONLY: The device handles TX aggregation > + * strictly in HW. Packets should not be aggregated in software. In addition to the discussion with Helmut -- this is also misleading since mac80211 doesn't, right now, aggregate anything in software -- it just handles session setup (which is what you don't want). johannes -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html